Electronics Forum: universal instruments 4796

PTF, how to feeder teach universal instruments

Electronics Forum | Mon Dec 12 09:02:30 EST 2022 | peterm

You teach the corners of the component picked from the previous steps. Just select "PTF RR BTWN RAIL" slot 75 in "feeder teach" and it should move over to the belt.

PTF, how to feeder teach universal instruments

Electronics Forum | Mon Dec 12 10:38:01 EST 2022 | poly

Cool, I do exactly that, I teach the bottom left and top right corner as it says... though maybe I should try the other ways. It gives me a totally wrong value.

PTF, how to feeder teach universal instruments

Electronics Forum | Fri Jan 06 08:28:47 EST 2023 | peterm

That's really up to you and for DTF what bank you're using it in so you can reach the pockets for teaching. Obviously easiest to keep them all the same.

PTF, how to feeder teach universal instruments

Electronics Forum | Mon Dec 12 09:56:07 EST 2022 | peterm

Feeder Teach. Then it's the "Slot X,Y feeder teach" in the pulldown menu. That should be the default one, set feeder slot and the PTF as your feeder. If in doubt you can always make a back up in the feeder database as well. Probably a good idea eithe

PTF, how to feeder teach universal instruments

Electronics Forum | Tue Jan 03 15:31:51 EST 2023 | griinder

I use a DTF instead of PTF, but one thing I wondered reading this...Which pocket do you designate as "First Pocket" for your tray in your Feeder.db? Could this be affecting the XY position being returned by the machine? For DTF I use upper left. Shou

PTF, how to feeder teach universal instruments

Electronics Forum | Fri Nov 25 11:55:22 EST 2022 | poly

So I'm attempting to run feeder teach for my platform tray feeder... but I've got no idea what first point I should teach is... normal is the end pin of the feeder but this is for the ptf conveyor... so I've got no idea. If I just teach each corner

PTF, how to feeder teach universal instruments

Electronics Forum | Thu Dec 01 14:48:48 EST 2022 | peterm

Hi, The detailed instructions should be in Voyager under PTF Installation. It's basically a kit where you pick up a metal plate and you teach that component on the belt directly. If you don't have access to the kit I'd just start of with the default

PTF, how to feeder teach universal instruments

Electronics Forum | Sat Dec 10 08:26:14 EST 2022 | poly

That procedure all works perfectly, and I'm read through that section of the manual however... 12. Perform Feeder Teach. Refer to the Feeder Teach Voyager help topic. I can't find anything in Voyager that explains the feeder teach procedure for t

PTF, how to feeder teach universal instruments

Electronics Forum | Mon Dec 12 09:41:57 EST 2022 | poly

Thanks Peter, when I open feeder teach i'm presented with a bunch of actions. I can't find docs on what the different actions are. Do you know which one I should do? I have attempted to teach the corners but the value it gives put the PTF pick point

PTF, how to feeder teach universal instruments

Electronics Forum | Sat Dec 03 01:07:29 EST 2022 | poly

I've got access to the universal manuals / voyager but I haven't found a section that describes the feeder teach setup process, I can pick up the teach slug onto the conveyor and then get into feeder teach but if I teach the corners of the slug as t

  1 2 3 4 5 6 7 8 9 10 Next

universal instruments 4796, 40097 searches for Companies, Equipment, Machines, Suppliers & Information