Electronics Forum: universal instruments hsp 4796 r (Page 1 of 1)

Re: HSP

Electronics Forum | Thu Jan 14 10:25:36 EST 1999 | J. Coogan

Doug The 4796A and 4796R machines maintain maximum tact time within an XY table movement window of approximately 17mm. In addition, due to their ability to perform "on-the-fly" theta correction, they are also able to maintain top speed for a larger

Sanyo TCM 3000 physical dimensions

Electronics Forum | Wed Dec 17 10:24:51 EST 2003 | kauerr

Hey, go to http://www.uic.com it is the Universal Instruments website. Universal sells HSP 4796 machines. These are actually Sanyo TCM 3000 Machines. We have 4 of them, they are awesome machines. Hope this helps, Curt

Re: Info on Universal Instruments?

Electronics Forum | Fri Jun 16 17:30:04 EDT 2000 | Eutectic state

Go with Universal. We had Fuji equipment for years. That is all but phased out now and we only are buying Universal. You cannot beat their service. The chip shooters are great. The only cons that I have dealt with is the learning curve on the n

Universal 4796HSP D2332 Unit drivers

Electronics Forum | Wed Sep 10 09:56:18 EDT 2003 | vickt

5 years ago (mostly likely 7-8 yrs). Most of these failures can be attributed to simple overtemp conditions or mechanical stress. Customers who do not keep the cooling fan filters clean on their machines tend to see a higher failure rate due to highe

HSP 4796B

Electronics Forum | Tue Nov 01 09:24:06 EST 2005 | UIC HSP Techs

The problem you report is very uncommon. Nozzles falling out of the placement heads can only be caused by severe mis-adjustment or failed parts. The following items should be checked: 1) Nozzle position hooks (on placement heads) 2) Clutch solenoid/

Re: Help with new placement equipment

Electronics Forum | Wed Oct 14 22:05:45 EDT 1998 | Jason

John, Universal has a smaller footprint HSP chipshooter, I believe the 4795S and the 4796R that takeup a lot less space than the full sized chipshooters do. I have a 4795S, it's just as reliable as our full sized 4795's & 96's. As far as BGA's I pr

Optimal Speed for Universal Chip Shooters

Electronics Forum | Wed Jun 11 16:30:33 EDT 2003 | T.Vick

You have received some great feedback so far. I would like to summarize and add a few points regarding maintenance. You should start (as recommended already) by verifying your component library data. Using the default values from the master library i

  1  

universal instruments hsp 4796 r searches for Companies, Equipment, Machines, Suppliers & Information