Electronics Forum | Mon Dec 05 09:14:14 EST 2022 | peterm
Invoke. The PTF Setup Procedure dialog box displays. 4. Select Product. The Select Product File dialog box displays. 5. Select the same product used in the Open PTF Teach Product section above. 6. Enter the Slot number for the PTF and select Full
Electronics Forum | Mon May 04 09:18:18 EDT 2020 | ilavu
Also, Check jumpers on 9pin connectors at front, rear and both side. If anyone missing or broken, will do the same.
Electronics Forum | Thu Apr 30 17:06:19 EDT 2020 | bboyer
So, I have inherited a couple of "vintage" GSM1 machines, and we've got one powered up, trying to see if it even works, before registering the machine and paying Universal some money. It appears several of the safety interlock switches are triggered
Electronics Forum | Fri May 01 15:35:03 EDT 2020 | travishemen
I'm not sure if these are similar to our Genesis machines but if they have removable feeder banks they are part of the safety circuit. If they are not installed or if the sensors on them are misaligned it will show the same as an interlock violation
Electronics Forum | Tue Apr 11 08:41:44 EDT 2017 | jdengler
Do you have an interlock bypass key? If you do can you reset the interlock in bypass? If you cannot, I believe there is a pico fuse on the interlock pcb in the control panel that may have blown.
Electronics Forum | Thu Nov 18 14:38:59 EST 2004 | EED
There is a couple of things to check. Put the machine in diagnostics and let the chain run. You should see it run the same as you would if purging it. Sometimes the 2 hall effects at the disk do not see the disk as it turns. Check the driver board
Electronics Forum | Mon Apr 10 15:47:47 EDT 2017 | jdengler
Mark, There is a way to read the I/O but without the electrical diagrams I cannot help you with that. When you press the interlock button does it go out? Jerry
Electronics Forum | Tue Apr 11 07:07:29 EDT 2017 | jdengler
That means you are not clearing the interlock condition. Probably a switch has been bumped out of place or sometimes a wire for a switch gets broken.
Electronics Forum | Thu Sep 02 13:19:52 EDT 2010 | remullis
I am having issues with the air dump on this machine. When you palm down or break interlocks the air dumps as it should however I'm getting a short burst of air back through the system. The problem with this is it's just enough to trigger the table l
Electronics Forum | Mon Apr 10 15:34:53 EDT 2017 | mrich208
Hey Jerry, The valve that sends air to the head of the inserter does not close when you press the "Interlock" button. If you press on the end of the solenoid with a screewdriver to force it the air makes it to the head. If doesn't seem like it is tr
