Electronics Forum: unloading and stations (Page 1 of 7)

Europlacer feeders and trolleys

Electronics Forum | Tue Jan 05 07:48:39 EST 2021 | mbass

Go for Gen 2 NT feeders, the Gen 1 Feeders tend to be problematic the older they get whereas the Gen 2 feeders are a much better prospect. I've used 8, 12, 16, 24 and 44mm. Some problems to look out for is pull back of coverlay and removal of waste

Board Stacking and Conveying

Electronics Forum | Mon Mar 26 16:58:53 EDT 2018 | solderingpro

Is there anything stopping you from replacing the flat belt solution to a continuous running steel roller chain conveyor? - From there (depending upon board temperature) you should be able to buffer your boards in a vertical buffer station if neede

Granite Surface and ESD

Electronics Forum | Mon Mar 28 09:56:36 EST 2005 | n wolford

We have a granite table out on our production floor. We use the table along with metal parallel bars and a height gauge to measure component height. Some of these boards have components on them that may be ESD sensitive. Does anyone have experience w

assembly serialization and traceability

Electronics Forum | Wed May 22 16:36:13 EDT 2002 | slthomas

What methods do you guys use for maintaining lot and/or board traceability? When I worked in med. products, we used travelers that we recorded everything on, then serialized them at the end of the build. Not as effective as up front serialization,

AOI, Quality and SPC

Electronics Forum | Thu Mar 06 11:37:17 EST 2003 | msivigny

Hello Phil, sorry for the confusion, because of our level of defect control and tracking at each process step, we did not use AOI systems at the time. We had a manual inspection station after reflow, then ICT and Functional/Final test for each produc

Feeder Calibration and Repair Station

Electronics Forum | Wed Jun 13 10:29:54 EDT 2012 | markhoch

Is anybody using the Argos Systems FVS2 FeederVision Station? It's half the cost of the ASM (Siemens) system, and appears to do more.

Rework and repair system suggestions

Electronics Forum | Fri Jan 28 09:30:07 EST 2005 | reash

Well the powers that be actually want to go with a regular rework station, for future growth. I guess they plan on using BGAs sometime in the near future. We're also planning on using a D-Pak device in this first board. So now we're looking at the

Feeder Calibration and Repair Station

Electronics Forum | Thu Jun 14 10:42:20 EDT 2012 | dlombard

Hi Mark How can I get one?

Rework and repair system suggestions

Electronics Forum | Thu Jan 27 11:45:04 EST 2005 | Mark

Based on the components mentioned, it sounds like you need a soldering station rather than a bga rework station. The equipment mentioned would allow you to rework fine pitch QFPs and BGAs. Reworking an sot-23 using one of those systems is inefficie

Manufacturing and test room cleanliness

Electronics Forum | Wed Feb 07 07:58:58 EST 2007 | ayelet

Thank you guys. So to summarize - no spec, just need to have decent cleaning... Are you familiar with dust events that caused burning of test stations ? Thanks Ayelet

  1 2 3 4 5 6 7 Next

unloading and stations searches for Companies, Equipment, Machines, Suppliers & Information

PCB Handling Machine with CE

High Throughput Reflow Oven
Selective soldering solutions with Jade soldering machine

Nozzles, Feeders, Spare Parts - Siemens, Fuji, Juki, Yamaha, etc...
SMT Machines

IPC Certification Training from the comfort of your home or office


"Heller Korea"