Electronics Forum | Tue Sep 13 07:32:51 EDT 2016 | bukas
that sounds like bad relay or relay control. are you in position to check it on relay pins? I would go from there.
Electronics Forum | Wed Sep 14 23:30:30 EDT 2016 | ariss_t
Hi, my 2cent.. u could try to check the sensibility of the camera board stop sensor.. maybe it detect something i.e support block.. do reply when u found the actual root cause.. thanks..
Electronics Forum | Wed Sep 14 04:09:21 EDT 2016 | jimmyh
We are enclosing our SMT room and will control the Humidity and Temperature of the room. Is there a standard for humidity and temperature for a SMT room and if so what is it. What is protocol if it goes out of tolerance? Do we stop production? Is
Electronics Forum | Tue Nov 08 01:46:43 EST 2016 | sarason
Some machines use air blowing to not only place the part but to also help guarantee that when the nozzle is sucking it doesn't end up with a net accumulation of solder paste inside the nozzle. Juki and Yamaha spring to mind. sarason
Electronics Forum | Thu Dec 01 13:35:21 EST 2016 | ttheis
I decided to replace the psu with three din supplies since it was a repeatable issue with the 5v rail. Machine is back in operation now with no signs of problems.
Electronics Forum | Sun Dec 11 22:05:53 EST 2016 | cmarasigan
Hello Sr. Tech, please disregard the board temp. it should be the actual value displayed, the PV at 145 deg. while the SP @ 140deg.
Electronics Forum | Sun Jan 22 12:16:28 EST 2017 | bamproto
Dear Mr. Sang, Have you checked the pick-up position. Could the nozzle descend too much and disturb the other components in the tape?
Electronics Forum | Wed Jan 11 15:18:24 EST 2017 | mrpackethead
When the YV100 starts up if you press a key during its startup you can get it to ascreen where it asks for passwords.. How would you get the passwords from this
Electronics Forum | Tue Jan 31 13:41:41 EST 2017 | tombstonesmt
Dow Corning 3-1953 is widely used when it comes to silicone based conformal coatings. Low odor, medium viscosity, can be atomized or needle dispensed. We have our operators fill syringe cartridges for any minor touch up.
Electronics Forum | Mon Feb 06 16:15:08 EST 2017 | ttheis
Great, that is encouraging. I did order a few needle sizes from McMaster to try out when we get the machine setup. What do you recommend for clean up the equipment?