Electronics Forum | Thu Mar 08 11:12:44 EST 2012 | eadthem
We just switched to using a paint marker to tag our xouts, and it fixed alot of the problems with using labels(causes over pasting) and using whiteout pens. what were using is the same brand we use in our inspection dept for tagging issues, UniPos
Electronics Forum | Mon Feb 20 15:17:54 EST 2012 | acsscott
Ok, getting further. We have 3 Philips CSM machines, new to the Topaz. Sorry for all the questions. We figured out that you have to press any key during the 6 second delay at power up. It then ask's for the password, or press the escape key to co
Electronics Forum | Mon Apr 02 11:01:04 EDT 2012 | vparis
None of those p/ns are coming up good, maybe > they're obsolete. Try contacting Cardinal > Circuit, they have tons of older MPM parts, _a > class=roll > href="http://www.cardinalcircuit.com/spare-parts-s > upport/" > target="_blank"_http://www.
Electronics Forum | Wed Feb 29 20:48:19 EST 2012 | pdl
I got one from PPM to set my machine up about two > months ago. They had it in stock and I think it > was $50.00 Yes i asked them and it was $50 when i asked but it was $120 to ship it to the uk. I have now got the drawings and have made one on
Electronics Forum | Wed Mar 21 21:35:11 EDT 2012 | aoiguy
I agree with Heg,and can say that I went through this process last year and ended up getting a Yestech FX series with an 8 micron camera. I haven't had any issues that they were unable to assist me with via email. There's a big market for AOI equipme
Electronics Forum | Tue Mar 27 06:59:58 EDT 2012 | JB
We have an issue with our Samsung Pick & Place. It comes up with errors. No sequence-finished from handler (%1) Loading SYSTEM data to DPRAM is failed Failed to create empty document No command response from handler. (0xffff) We have tried swap
Electronics Forum | Fri Apr 06 11:10:43 EDT 2012 | cadco
We are a PCB design house/CM and we have found that if you elongate the QFN pads to the outside of the part by .025 to .030 you then have the opportunity of doing touch-up manually with a soldering iron should there be a voiding issue. This would hav
Electronics Forum | Wed May 16 09:23:04 EDT 2012 | jeremymek
In my experience Both Dek and speeline machines are good used. personally I think speedline seem to hold up better when PMs have been ignored though. Also make sure you can get a third party board support system into it like a gridlock or Vacunest
Electronics Forum | Fri Jun 08 16:36:58 EDT 2012 | noid
KIC 24/7 has evolved into RPI. Not only will it give you virtual profiles, it also gives you DPMO and yield, based where each board lands in the process window. The good thing about this software, you can go back a year later and look up a specific
Electronics Forum | Tue Jun 05 17:31:08 EDT 2012 | swag
Do you see any issues with grid lock on double sided boards? My concern is that you set it up for the first board second side (populated side down) then you might have parts that aren't exacly at the same height on the next boards due to shifting or