Electronics Forum | Fri Feb 22 13:48:27 EST 2013 | cyber_wolf
I have been told that stencil nano-coatings are rain-x in a different container. I guess I half believed it until I opened up a sample the other day. It smells EXCACTLY like rain-x. For those of you that have never smelled rain-x it has a very distin
Electronics Forum | Wed Mar 06 22:15:24 EST 2013 | dman97
Hi. Does anyone know the difference between a Radisys EXP-VID video card and a Radisys EXP-VID-B? I need to know if they are the same card because the one in my machine is dead. I am looking to get a replacement but both of these part numbers come
Electronics Forum | Thu Mar 14 10:49:44 EDT 2013 | babe7362000
Have others seen a higher rate of machine downtime due to the cover tape on parts not pulling back properly. We have the same problem on the Jukis and Quads. About every 3 minutes the machine stops and the operator has to pull the tape back. And in
Electronics Forum | Thu Mar 14 17:35:39 EDT 2013 | dontfeedphils
Have you looked at the cover tape wheel on these different feeders and made sure that they are turning correctly when the feeder is advanced? There's not too many things that could be wrong, either the wheel isn't turning properly and keeping the co
Electronics Forum | Fri Mar 15 12:48:01 EDT 2013 | anvil1021
Hello All.....wondering if anyone out there has needed to isolate a QFN ground pad from the device and how you may have gone about it. We are thinking about using a micro drill to remove the pad, but if anyone out there has a better idea I would be v
Electronics Forum | Fri Mar 15 18:44:34 EDT 2013 | anvil1021
We will try both the solder mask and the .001" Kapton and see where we end up with each. This is a fine pitch dual row QFN and we cannot afford too much paste on the .004" stencil we are using. We have experienced shorting in the past with .005" sten
Electronics Forum | Wed Mar 20 14:21:28 EDT 2013 | jeffharley
Hello All, I am wondering if anyone has come up with an easy and safe way to drain a solder pot on a wave solder machine? We are getting rid of an old machine and replaceing it with an newer machine and we want to use as much of the solder from the o
Electronics Forum | Tue Mar 26 11:37:39 EDT 2013 | dman97
Hi Deni, I have access to the online database, but I don't see the option for machine manuals. I only see the trouble shooting guide. 2 of my machines are running a variant of UPS 3.1 on OS/2. The other machine is running an older 1.4 OS/2.
Electronics Forum | Mon Mar 25 13:18:05 EDT 2013 | emeto
Hello, I have an issue with SOD 923 out of the oven. The part looks grainy, doesn't show a good wetting and looks like it has to be touched up. Everything on the board looks beautiful except this part. I tried with the profile, I checked the pad des
Electronics Forum | Tue Apr 09 22:32:05 EDT 2013 | jeffr
There is no easy way... but this is how I do it.. Origin the R axis, losen the idler bearings on the belt, remove the C clips at the top of the heads, lift up and remove the spindle assemblies being careful not to lose the 2 balls in the side of the