Electronics Forum | Tue Aug 15 02:45:14 EDT 2006 | dman97
Does anyone know if it is possible to lower the camera brightness when selecting fiducials? Our UP2020's camera is extremely bright and sometimes it causes the fiducials to be rejected cause they are too bright to be seen. Any settings than can be a
Electronics Forum | Tue Aug 15 09:40:43 EDT 2006 | SWAG
Not sure about 2020 but AP's have an option to perform a histogram test/adjustment on the lighting. It's a black card, white card test and you can adjust a pot. in the machine to make the histogram curve "best-fit". On an AP, you find this option i
Electronics Forum | Fri Apr 24 17:42:04 EDT 2020 | rodrigo
I checked and the fine theta motor is spinning. Thank you so much for the help.
Electronics Forum | Sat Sep 19 21:50:19 EDT 2020 | davef
Use your 3D printer to make a "case" for your board that will hold the battery securely against the contacts on the board.
Electronics Forum | Mon Sep 14 22:59:42 EDT 2020 | kylet
Looking to power up this board with 3v coin battery. I've tested this board with it and it works but to solder this on or make something that has clips for the attachment to power this up. Positive and negative connections are the circles on the inne
Electronics Forum | Tue Apr 28 09:27:53 EDT 2020 | assuredtech
On power up, push and hold the F1 key during the complete boot up, this will force the machine to boot into it's I/O menu, this allows you to verify the conditions of all of the sensors and confirm if it is waiting on an input from a sensor. Most com
Electronics Forum | Wed Apr 22 12:50:39 EDT 2020 | rodrigo
Hi all, One of our Fuji CP-642 machines has a weird problem. It does not happen every time but often enough that it is a problem. I power up and press start to zero it. The problem is the zero...ing does not finish. It moves the xy-table, D1/D2 table
Electronics Forum | Wed Apr 22 14:57:46 EDT 2020 | travishemen
It seems like we had a similar issue once on a CP643. If I remember right it ended up being either pre or post theta. The amplifier for the sensor quit working and it was trying to zero the theta motors before doing the cam. The LED indicator on t
Electronics Forum | Thu Oct 20 23:09:53 EDT 2005 | Cmiller
I think I have an extra set of manuals for a UP-2000, 2020. Should be close. You will have to pay the shipping. E-mail me at cmiller@adltech.com and I will try to get them to you.
Electronics Forum | Wed Sep 08 22:13:07 EDT 2004 | Frank
Our Juki KE-2020 can place up to 74mm X 74mm ICs and BGA. I am have placed this zif socket before on the KE-2020 that you are speaking of. I don't think the KE-2020s are being made any longer. I know the new KE-2060 machines (that replaced the KE-