Electronics Forum | Thu Aug 25 08:22:41 EDT 2016 | bobpan
If I have to guess then I would say the machine is first picking up a larger nozzle to pick up this part.....the nozzle is not seating on the z-rod correctly and causing a problem. Check to make sure the nozzle is being mounted correctly. You may als
Electronics Forum | Wed Aug 31 09:45:36 EDT 2016 | ttheis
I have a smema conveyor connected to the downline fmi connection on my up500 but the fmi sugnals show the coneyor ready signal going ro the upline ready input (screenshot). The downline ready output is activated qhen a board is output from the printe
Electronics Forum | Thu Sep 08 13:14:11 EDT 2016 | claudea2
Hello, we have an Ekra E4 that we bought used and the stencil wipe never worked. We found that the air tubing for the up (black)& down (blue) of the wipe roll is missing. There are 2 push connectors for up and 2 for down to receive the tubes. Does an
Electronics Forum | Mon Oct 24 09:07:58 EDT 2016 | robl
Could you make up your own adaptor cable to connect to your programmer, then fit a small form connector like a Firewire on the edge of the PCB? It should only take up about 7x7mm of real estate as opposed to a 2.54mm 5x2 pin header 12.7 x 5.08, or a
Electronics Forum | Wed Nov 09 10:30:26 EST 2016 | jbreit
You're right. It is BS. I should have said "the operators are only WILLING to remove so much paste manually." When I brought up my concerns about leftover paste with the powers that be, I was told in no ambiguous terms that the operators will no
Electronics Forum | Sun Nov 06 16:10:25 EST 2016 | teslalab2
Hi! I have a Quad IVc pick and place that runs dos. The GUI computer is a compaq prolinea 4/33s. The hard drive went stupid mode and now wont respond. I have all of the data backed up. I tried transferring the files to a fairly modern hard drive (20g
Electronics Forum | Thu Dec 08 01:44:44 EST 2016 | cmarasigan
We are currently experiencing with our SMD Solder Reflow Equipment on Shooting-Up Zones (Zones 3,4,5,7 & even Cooling Zone). PV exceeds about 5-10 degrees with the SP. (ex: SP=140deg, actual PV = 145deg & higher). Our equipment undergo a monthly prev
Electronics Forum | Tue Mar 28 19:56:47 EDT 2017 | aemery
Dale, Be very careful about putting to much grease into this actuator. It is kind of a sealed unit. If you were to take this actuator apart you would see that the motor drives a heavy pitched threaded screw. As it turns it causes the threaded tube
Electronics Forum | Fri May 05 10:49:54 EDT 2017 | dontfeedphils
So I think I've given up a bit on the FR4 coupons due to complexity and having to custom order them every time we'd need a reorder. In the past I've used aluminum coupons, about the size of a regular business card. Some extensive googling hasn't tu
Electronics Forum | Thu May 18 13:00:27 EDT 2017 | stephendo
If the OEM is doing the installation then phone up the sales guy to touch base and find out what you have to have ready for when the tech shows up to install it. The sales person will want everything to go smoothly as much as you do. Play your cards