Electronics Forum | Wed Jan 24 22:46:08 EST 2007 | fastek
It wasn't IPC's choice. They were kicked out of Anaheim because it takes too long to set up and dismantle the APEX show. At least that was the story going around last year at this time.
Electronics Forum | Sat Jan 20 18:54:47 EST 2007 | al
First I would check the cable,swap it with another fuji machine! Or have you tried to "reset start".risky if you have no comms but you need to get to the bottom of the problem...
Electronics Forum | Tue Jan 23 13:10:10 EST 2007 | jax
This is something a DFM should catch. Best Option: Add Break-Away rails to the board. Worst Option: Buy a true on-contact printer... (normally referred to as the Y-Snugger option)
Electronics Forum | Wed Jan 24 08:12:21 EST 2007 | Hussman
Turn off Grid-Lok, turn off side clamps. Use hand inserted tooling (yeah, you may have to do some thinking here)for support. If you have vacuum, turn it on. People still use Grid-Lok?
Electronics Forum | Wed Jan 24 13:25:26 EST 2007 | pr
Grid-lok only supports the board, so why would what I suggested defeat the purpose of the grid-lok? You still falling down when you mark your golf ball, Tyrone?????
Electronics Forum | Wed Jan 24 16:24:47 EST 2007 | Tyrone Jamal Washington
man I play golf once wif dis chubby angry guy. Got mad and accused me of dancing in his backswing. never played after that.
Electronics Forum | Fri Jan 26 15:45:55 EST 2007 | mumtaz
i will get revenge.i run this mashine since inception. you get yours one day
Electronics Forum | Thu Jan 25 15:39:07 EST 2007 | electrovert
We swapped the solid state relay for zone 5 bottom to zone 5 top but the problem came up once a while. As for noise protection, there are jumpers at E1 to E8 and E9 to E16. They are hardware filters and prevent noise spikes from affecting thermocoupl
Electronics Forum | Fri Jan 26 09:49:53 EST 2007 | dyoungquist
You should have no problem using lead-free components with tin-lead solder. Is your reflow oven IR or hot air? If you are using an IR oven and the components are white or light colored, they may not be heating up enough for the solder to flow on
Electronics Forum | Thu Feb 01 10:40:49 EST 2007 | Hussman
Wow, where'd that come from? Someone asks for help and people with experience with both machines posted. Seemed staright up to me? You own Juki Loco?