Electronics Forum | Tue Jun 10 23:06:28 EDT 2014 | demzvill
In our assumption also, nozzle is magnetized because the chip termination is made up of alloy so possibilty that when there is excessive contact between two metals there magnetic field produce, so during z up chip is magnetize on the nozzle causing i
Electronics Forum | Fri Jun 13 13:19:54 EDT 2014 | cyber_wolf
That little cylinder comes apart. Sometimes they get gummed up and need to be taken apart and cleaned.If it does not make the sensor in time, it pops an error up.
Electronics Forum | Thu Jun 26 05:07:19 EDT 2014 | bobpan
On the older machines if the z-axis has springs on them sometimes they get weak and when you open the door the z will not stay up. Before closing the door manually push the z up if they are dropping down then enable the motor power. If this is the ca
Electronics Forum | Thu Aug 14 02:29:48 EDT 2014 | rusigan
Yes it is new.The technicians that have set up the machine did not have the feeder manual up until yesterday afternoon.They managed to sort the problem out by referring to the manual.The EX-Feeders needed to be programmed on the feeders itself.Thanks
Electronics Forum | Tue Sep 16 17:03:34 EDT 2014 | rangarajd
We have an issue with solder wicking up the leads/ inside terminations on an SMT connector. The solder coverage is sometimes over 50% of the connectors inside pin length. The terminations are gold plated. Is there an IPC spec for acceptability? Plea
Electronics Forum | Thu Feb 19 12:29:19 EST 2015 | tnisbet
We stock most sizes of Squeegee blades as well as most replacement parts for the UP 2000. We have service technicians for feild service & phone support. many of our parts are listed on our website: http://www.ppmparts.com Tom NIsbet PPM
Electronics Forum | Wed Apr 08 00:21:28 EDT 2015 | tchaovalit
I'm looking for Pick and Place machine with Up Looking Camera. Pls advice where i can find it. Regards Chaovalit
Electronics Forum | Tue Jun 09 09:04:58 EDT 2015 | lisaaci
Its not picking up the nozzle from the changer. It either doesn't at all, or leaves the nozzle partially in the changer.
Electronics Forum | Fri Jun 12 14:19:03 EDT 2015 | tdemon69
i have a up 3000 ultraflex. the lower half of the tactile sensor is stuck down. i have replaced the driver board, check wire down to drive board,check the fuse for power on the driver board.
Electronics Forum | Tue Aug 18 21:42:48 EDT 2015 | comatose
Why not just pick up something like an old Camalot 1414 and use that? Then all the work other than rigging up a valve is already done. 1414s go for a couple or five grand in workable condition, especially without a pump.