Electronics Forum | Sun Feb 03 11:10:13 EST 2008 | fastek
Pretty simple explanation really as it's happened to equipment I have sold and sent to Asia. If the paperwork on the importer's side of the transaction isn't up to snuff or they haven't paid off the right guy to get it in the country, the machine w
Electronics Forum | Tue Apr 01 17:14:11 EDT 2008 | aj
Hi, We only have 2 lines , but I dont allow any of the Ops to set them up, I did once and winded up with 10 damaged nozzles and cracked caps on the boards ... If the problem is as big as you say it is , you should really spend some time setting it
Electronics Forum | Thu Apr 17 07:54:02 EDT 2008 | davef
Our quality types wouldn't allow: Q16 on "1up good board2.jpg", Q17 on "1up good board.jpg", or Q15 on "1up good board3.jpg". They'd probably pass Q13 on "Q13 next to Q14 no-reflow.jpg", if it wasn't part of a bigger issue. Again, you appear to have
Electronics Forum | Wed Jul 09 12:43:18 EDT 2008 | grics
I think this depends on what you are reporting as defects... I would place my inspection first, team up my Touch-up/Rework into one category. If for any reason I need to hit a joint after leaving my oven, that to me is classified as a defect and s
Electronics Forum | Wed Aug 13 09:11:19 EDT 2008 | rgduval
Shane, We're assuming that the software is similar to our Heller 1800. We're also assuming that the oven has thermocouple ports, and that you have the thermocouples to plug into them. From the screen that displays the zone data, there should be a
Electronics Forum | Wed Dec 03 16:16:18 EST 2008 | grantp
Hi, Ok, and thanks for the heads up on that, and I will contact them and see what model that is. I liked one of their manual printers, as it looks like the board slides back on linear bearings and then lifts up under the stencil, instead of the usua
Electronics Forum | Thu Sep 24 17:00:03 EDT 2009 | dogsbody
would any body be able to supply me with infomation on how to adjust a quadalign unit,as a unit on my line will not pick up 0603 resistors,but will pick up thicker 0603 caps. My manuals offer no help.I have run the aligner calibration with the cone t
Electronics Forum | Mon Sep 28 10:51:02 EDT 2009 | shanenaturalpoint
My company recently purchased an MPM AP27 on the used market. I had the machine up and functional at one point, but now it is inoperable. I have correct power and air to the machine, but when I attempt to power it up, I get nothing. Red light on t
Electronics Forum | Tue Feb 02 17:10:03 EST 2010 | flipit
Remember this is a 30 layer PCB. If it is built in a multi up panel, there is lots of room for error. Lets say there are 10 circuits per panel. Say you have a 10% scrap rate that happens randomly within the 10 up panel of circuits. Apply this 10%
Electronics Forum | Tue Aug 03 11:40:41 EDT 2010 | swag
HSP nozzles get pushed back up into the head by a cam with a pneumatic brake on it. Make sure this is functioning properly. It is not uncommon for the MAC valve that actuates the brake to get flaky = replace it. Also, the nozzles are mechanically
