Electronics Forum | Thu Mar 17 13:03:21 EST 2005 | Slow Ride
When it comes to solder paste, you should worry about volume. Granted height is a part of the equation, but you could have perfect height and still get defects. I wouldn't get too wrapped up in volume either, unless you're evaluating stencil height
Electronics Forum | Thu Mar 17 15:03:23 EST 2005 | debh
Has anyone ever tried to use "Reel Scan" (brand) barcoding with Juki machines. We currently have 730-2020 and 2050-2060 lines set up. Was wondering how the compatibility is. (I think I already know the 730 is out...) I'll be asking the vendor also, b
Electronics Forum | Sat Mar 26 08:30:01 EST 2005 | davef
Consider this: * SolderQuick Winslow Automation-type [ http://www.winslowautomation.com ] preform * When LGA first came on the scene, we didn't have a clue. After trying sockets, we printed paste on the pads bug-up, reflowed, and then the placed the
Electronics Forum | Mon Mar 21 08:19:54 EST 2005 | Bob
Sounds like a flaw in your trap. It seams that during the pumping process the trap is ineffective or open, allowing normal sewer gases to bypass the trap and stink up your SMT area. This is similar to what happens when you do not use a drain for a lo
Electronics Forum | Mon Mar 21 21:28:41 EST 2005 | pmd
I agree with dave. Two things prevent oders from drains. The "P" trap and the celing or roof vent. If the system is sealed from the pump on then it should run thru a "P" trap this prevents vapors from comeing back thru the pipe. To make sure suction
Electronics Forum | Wed Mar 23 18:37:30 EST 2005 | KEN
We currently have about 800 active stencils. You Need a phase out program for your customers products. Otherwise you end up in stencil hell! Additionally, our smt team uses an access database to find what they need. Customer, assembly,revision, s
Electronics Forum | Mon Mar 28 18:05:13 EST 2005 | darby
The Yamaha manual is pretty straight forward on this one so I presume the "Philips" is as well. Go to the Maintenance, Repair and Adjustment chapter and look up Drift-Adjusting. It is in the Controller section. If you don't have a manual let us know
Electronics Forum | Wed Apr 06 09:16:31 EDT 2005 | blueflag
Ive just checked all the cables that i can see and there seems to be nothing wrong. Have just put a brand new fuse in to mot z card and it has blown it. machine boots up, initiate the hardware and everything goes ok until it does the z height then i
Electronics Forum | Wed Apr 06 11:47:17 EDT 2005 | jdengler
Dave, Most dust and other crud is actually generated inside a plant. While working at another company they brought in consultants for this same issue. I don't remember the exact amount but only around 20% comes from the outside. Unless you are
Electronics Forum | Thu Apr 07 06:10:08 EDT 2005 | siverts
There are some equipment out there for this purpose, that roll some type of "sticky paper" over the pcb. BUT with this type of equipmnent, there is a high risk of loading up the pcb:s with static electricity. Therefore You must consider to use some o
.gif)
