Electronics Forum | Tue Feb 27 13:43:42 EST 2007 | wavemasterlarry
Thanks Russ. Everyone knows that when you clean your wave you wear a dust mask. Well that tells ya the lead is flying around. So same goes fr your oven. Hot solder paste turns into the lead. And like a wave it is very hot. Hot stuff vaporizes l
Electronics Forum | Wed Feb 21 16:07:23 EST 2007 | Jon Elson
The ad is confusing. He has NO feeders! That certainly reduces the value of the machine. Now that I know the general capability of the machine, I'm inclined not to go for it. With shipping, feeders, possible repairs, etc. it could be real expensi
Electronics Forum | Thu Feb 22 09:21:57 EST 2007 | Cmiller
Mydata would be good, Contact Systems would be good for what you are doing, very good software, crappy feeders but fine for 0805 parts. You may be able to get a Universal GSM pretty cheap these days. If you make a decision then look for a machine you
Electronics Forum | Thu Feb 22 18:28:28 EST 2007 | Cmiller
You could probably put a 1/4" plate of steel over the aluminum and make some shorter magnet pins. I think the factory upgrade was $3500 to $4500. Its hard to justify the cost based on saving maybe 5 minutes a set-up for an operator. But your lines wi
Electronics Forum | Tue Feb 27 18:26:21 EST 2007 | jmelson
The machine is 2000 miles away, and the eBay auction has not closed yet. I'm working from what pictures and spec sheets I can find on the net right now. If I do win the bidding, I will need to be sure there is an opening wide enough for the machine
Electronics Forum | Wed Feb 28 10:27:55 EST 2007 | Rob
Hi John My understanding of your post is that you are asking if anyone has tried to enforce MSL levels or reflow parameters onto the component vendor/manufacturer. Is this your question or am I mis-interpriting it? If that is the case you will not
Electronics Forum | Fri Mar 02 11:26:17 EST 2007 | ausajid
hi thank you very much for your advice. there was only one option i beleive that should work, i have tried that option today, but still the machine goes to the alternate carrige instead of alternate feeder. the option was in operation mode, alternat
Electronics Forum | Tue Mar 06 08:33:40 EST 2007 | cardinal
You can get a topside edge-clamping system to fit your AP HI E printer from Gridlok. They make a universal tooling system and topside edgeclamping system for the AP series and UP 2000 series printers. The Y snugger tooling option when ordered with t
Electronics Forum | Mon Mar 05 07:59:11 EST 2007 | jdengler
Mark, I will begin by saying I am a big fan of Fuji equipment so I would not recommend anything else if you already know them. You say you get 70K placements a month with these 2 lines? Do you mean 70K boards a month? The first place to look a
Electronics Forum | Mon Mar 05 15:29:50 EST 2007 | ck_the_flip
When no-clean flux and no-clean soldering first came out in the late 80's / early 90's, there were lots of White Papers written about conformal coating adhesion and no-clean flux. I'm pretty sure all CC's will adhere to today's chemistries. To be o