Electronics Forum | Thu Apr 01 14:43:26 EDT 2010 | cbart
You say its in both smt and through hole, but, are you waving the SMT parts as well, I assume yes since you think its dross in the joints. Questions: 1- do you have higher mag scopes that you can zoom in a little more to see if these are voids or dr
Electronics Forum | Thu Apr 08 14:57:15 EDT 2010 | davef
Why don't threads post in proper sequence? Look here: * http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=61576 * http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=61574 * http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=6
Electronics Forum | Mon Apr 26 03:04:15 EDT 2010 | grahamcooper22
I always fix thermocouples to pcb pads across its width. Then rotate it 180 degrees to check readings. If I am happy that the oven is giving results within a few degrees C then I'll crack on and set up a soldering profile. I am not sure what the oven
Electronics Forum | Fri Apr 30 07:39:54 EDT 2010 | jdengler
We do a similar part on a Fuji IP3. Set table speed to low. I do not know the QP, but if it's similar to the IP make sure the board clamp/unclamp is smooth. On our IP it got dirty and was jerking causing the board to jump a little which bounced ou
Electronics Forum | Thu May 06 11:37:48 EDT 2010 | davef
There is no specification. Shear tests are very material / operator dependent. BALL SHEAR TESTING OF RAW BGA DEVICES: A total of 3 devices were subjected to ball shear testing. Results of the testing indicated shear values in the range of 0.7-1.25
Electronics Forum | Tue May 11 10:57:35 EDT 2010 | ehess
Having a problem where i have no drive on any axis. Machine powers up, but won't reset. I have 24VDC from PS6 and PS1, located in the upper drawer. I do not have 12VDC @ PS2 in lower drawer. troubleshooting guide says to check DPR in/out, which I
Electronics Forum | Sun May 23 21:33:42 EDT 2010 | ashley
"The part is picked up and head goes to it's xy location" Hello mickd, I believe VP had passed but machine is confused how to compensate & place. OS error normally associate with a faulty VME card. Please check the following :- VM1152 VM1730 VM193
Electronics Forum | Tue May 25 13:03:35 EDT 2010 | jdumont
Hello, I have no experience with CE-1155 but a ton with 1B73. I would say Justin hit it right on the head. 1B73 does not like to be anywhere near silicone residues. We make sure the boards are handled with gloves after wash, before coat. Unfortunat
Electronics Forum | Sun Jun 06 13:03:14 EDT 2010 | whitewing
I'm sure you could buy everything you need to make your own stencils in-house for way less than 200K - lasercut or photochemical etch. If you have someone local with a typesetter of photoplotter , photoetch should be really cheap to set up. I've also
Electronics Forum | Mon May 31 11:04:06 EDT 2010 | aj
Hi Manuel, Do you not have a fine pitch placer?if not may be you need to slow down the placement speed on the QFN - I would imagine you would get a lot of fails trying to use the vision to pick up the component lands. We place thousands of QFNs and
