Electronics Forum | Mon Sep 27 10:45:19 EDT 2004 | JDumont
Morning all, Can anyone recommend a simple low cost method to spray apply conformal coating to our PCB's. Looking for something simple, semi-automatic, and repeatable for operators to use without problems. This is a very low volume application, appro
Electronics Forum | Wed Oct 13 12:12:20 EDT 2004 | haviland
Good morning. We have a used Nordson Coater, Batch type (not pass thru), w/o cure oven,that you can purchase for $9,950.00. Unit has been cleaned and lines purged. It was running when decommissioned, and is still in nice shape. Thanks, Nick Haviland.
Electronics Forum | Fri Oct 01 14:06:08 EDT 2004 | russ
after we teach their positions We tape the sticks down. It is also helpful to make sure that you tighten the "discs" that are located on the tension rods. There are available if you desire guides and stops from Samsung that attach directly to the fe
Electronics Forum | Mon Oct 04 20:06:31 EDT 2004 | davef
We know SIR coupons are not ROSE coupons, but coupon boards are: * IPC-B-24 (copper and HASL, FR-4 and polyimide) * IPC-B-36 (bare copper and HASL, FR-4 and polyimide) * IPC Phoenix board (bare copper, FR-4) * IPC-B-25A (FR-4, bare copper only)
Electronics Forum | Wed Oct 06 13:41:38 EDT 2004 | pjc
Here are some of the leading mfrs.: http://www.pressureproducts.com http://www.smartsonic.com http://www.aqueoustechnologies.com http://www.emcgti.com http://www.jnjultrasonics.com Using ultrasonics has proven to be most effective at dislodgei
Electronics Forum | Wed Oct 13 11:54:48 EDT 2004 | raj_nz
We use a Yamaha YV100XT pick and place machine, we have just discovered this new error, during operation or resetting after making some changes on production data the machines freezes and the keyboard and controller freezed. to get it back to working
Electronics Forum | Tue Oct 19 07:52:51 EDT 2004 | mksslcheng
If there has general standard to guide which type of component can not be cleaned ? No-clean flux be used in solder process ,and the PCBA we build be subject to the filed of high frequence (13.56MHz). Is it very critical if the coating that adhered
Electronics Forum | Sun Oct 24 20:55:45 EDT 2004 | christina
Dear Chris Thank you so much for the prompt reply and it really helps. Do you have any SMT experience for rig-flex boards? Can you share with me about the differences with that of rigid boards? Is there any special precaution needed? When you were d
Electronics Forum | Tue Oct 26 00:49:42 EDT 2004 | pilengr_tw
Yes, we have an SOP on how to measure. Basically, calibrate the measuring device and measure tension on the 4 sides and one at the center of the stencil. All measurement should be within 30 ~ 50 N/cm otherwise we will not use it and return it to sten
Electronics Forum | Wed Oct 27 02:13:21 EDT 2004 | Joseph
Dear all, The problematic IC being X-rays and shown excellent wetting with no solder voids. Meanwhile the samples to be sent for independent party to verify the failure, e.g. using SAM method. The condition of failure is the PCB assembly fail functi