Electronics Forum | Sat Aug 07 04:11:57 EDT 2004 | AOI Solution
This is Ivan from TRI USA located in Santa Clara, CA Our company provide a Solder Paste Inspection System which uses 635 Line Laser to scan the panel and come out a real 3D height, area and volume measurement! We sold lots of this system in Asian EMS
Electronics Forum | Sat Jul 17 10:04:39 EDT 2004 | stefwitt
I think we should shift this issue to the machine suppliers, requesting changes in the machine design, in order to keep at least the jobs of high mix, low volume in this country. We can only compete with low labor cost countries by increasing the lev
Electronics Forum | Fri Jul 16 20:17:15 EDT 2004 | cisridn
Hello! I am an Electrical Technician with Filtronic Comtek. I am responsible for all of the Engineering changes and rework done to prototype and pilot run PCB's. My current rework equipment includes: Soldering irons, heat gun, and hot plate. Consid
Electronics Forum | Mon Jul 19 14:58:50 EDT 2004 | mattkehoe
We have a need for expert opinions on a solderability issue. Our company prints and then reflows solder paste with no components in place. It is then washed and flattened with a special flattening machine. Usually, the paste fuses and spreads out
Electronics Forum | Thu Jul 22 07:52:37 EDT 2004 | Chris L.
Hi Grant, The purpose for allowing the solder paste to reach room temp before production is to reduce the amount of water absobtion from the air. (e.g. a cold glass of water "sweats" on a humid day)The purpose for mixing is to make the viscosity more
Electronics Forum | Sat Jul 24 11:57:50 EDT 2004 | KEN
I wonder what that would look like? BUILD DCOUMENTATION Paste: OA XYZ-123 SOLDER PASTE. Note: Place refridgerated paste tube in Goldstar Microwave (3rd from the end of the break-room). Press "defrost" "forzen dinner". Do not defrost solder paste
Electronics Forum | Mon Jul 26 06:32:58 EDT 2004 | cyber_wolf
Grant, The only thing that you really gain from refrigeration is a couple more months� shelf life. Refrigeration also seems to slow down flux separation. I am not sure how your paste consumption is, but we use ours up way before the expiration date
Electronics Forum | Tue Jul 27 22:30:19 EDT 2004 | KEN
Sr. Tech, when you say you have never had a problem, what exactly does that mean? How do you know you have never had a problem directly associated with your solder process? Do you actively measure your defect levels? How do you maintain traceabili
Electronics Forum | Fri Jul 23 09:12:34 EDT 2004 | davef
We have run not AgPd [that we know of]. We can comment on PdNi. [But you're probably have Ni under the AgPd] In general, palladium solution rate is much slower than other sacrificial finish materials that we use for the purpose. The key then is to
Electronics Forum | Mon Aug 09 10:30:25 EDT 2004 | AJ
celldude, I have a couple more questions for you. Where can one look into getting these machines necessary for SSD? Also, knowing that the machines are expensive..Does your company find they are saving money (in the long run) by using SSD? More spec