Electronics Forum | Sat Apr 15 09:07:22 EDT 2006 | samir
Amol, We pulled off this "hybrid profile" with a leaded solder paste. We recently got our tensile test report results, and our Pb-Free BGA / Pb Paste sample broke off during tensile tests at the pad/substrate interface, and not the joint. This ind
Electronics Forum | Tue Apr 18 12:34:15 EDT 2006 | Chunks
Outside the box: Can you retro your oven with a belt chain combo? I always order my ovens this way just in case. No pallet or carrier needed then. Can justify retro against the cost of the pallet or carrier. Two part epoxy instead of heat cure?
Electronics Forum | Wed Apr 19 20:33:14 EDT 2006 | davef
I just flew in from (insert city) and boy are my arms tired. pr: Likely, you're correct. The "pound-inch" units should have been the give-away, for us. Good catch. If this is the case, the frame fabricator would be the best source for tensioning
Electronics Forum | Wed Apr 19 16:43:05 EDT 2006 | samir
Silicone-based coatings "repel" most foreign,non-compatible materials like peelable solder mask, and rubber or vinyl boots. The result is, uncured material around the vicinity of where the boot was. Trust me. Been there and done that. As a rookie
Electronics Forum | Thu Apr 20 13:50:28 EDT 2006 | fredericksr
All, Does anyone sell a safe and effective way to connect a DMM to building ground via a power outlet? Personally, I'm comfortable using a banana plug, but the people that are going to be performing this task may vary in electrical understandin
Electronics Forum | Mon Apr 24 09:43:47 EDT 2006 | printerman
What you describe is the X snuggers fitted into the workholder which do need either a flat board or good vacuum to work. There are several solutions. One solution you can try yourself is to use Vacuum cups, ( bellows type) designed into the workholde
Electronics Forum | Sat May 13 00:17:40 EDT 2006 | George S
I had Mydata for several years, and got a Juki 2060R about 8 months ago. If I had to choose today, it would be Juki again. The features which help me are bank changing, where I can set up offline and change over in two minutes for all feeders. The
Electronics Forum | Tue May 02 07:46:39 EDT 2006 | Bob R.
Be careful about taking any generic advice and trying to use it to reduce voiding for your particular paste with your particular boards. I've done a few literature searches over the years on causes/cures for BGA voiding in the SnPb world and found a
Electronics Forum | Fri May 12 11:40:25 EDT 2006 | solderiron
If you can change to SN100C do it. The nickel prevents the high tin content from eating away at the metals on the tips. Similar to what the Lead did in 63/37 alloys. This Koki crap is just that, crap. 99% tin??? Thats what is causing the problem peop
Electronics Forum | Fri May 12 06:13:55 EDT 2006 | slaine
Hi I use a lot of preforms for other specific applications. Personally I like indiums product but the lead time is awful and dont often deliver them on schedule. (im in the uk). Some manufactures make preforms out of solder wire that is pressed flat