Electronics Forum | Fri May 23 19:59:26 EDT 2014 | jhaye
hi everyone, I just got some question with regards to the life span of components from the date it was packed from supplier. Does the parts more than 2 years from the date it was process by supplier: 1. Can it still be used in PCBA?? 2. will it not
Electronics Forum | Wed Jun 04 21:11:11 EDT 2014 | isd_jwendell
This style gave me grief as well. The problem is the way the part is manufactured leading to an unusual pad configuration. When the part is placed on the PCB there is no pad wrap under the part, the pad is 90 degrees to the board. The datasheet shows
Electronics Forum | Sun Jun 01 13:25:26 EDT 2014 | davef
Eurolanders and Asians are the primary users of immersion tin. In the US, the use of immersion tin is restricted due to the concern over the thiourea that used in tin plating process. Thiourea is a suspected carcinogen. I’m inclined to say, “aww, as
Electronics Forum | Fri Jun 27 13:33:59 EDT 2014 | rgduval
I agree with all other posters...strips on the Y-Wagon have always worked out, rather easily. Some people I've met consider it a benefit to having a MyData. However, I would add that MyData's handle strips in the feeders better than most other pick
Electronics Forum | Fri Jul 04 07:11:43 EDT 2014 | padawanlinuxero
Hello We work with a TP9-4 and a MY12 both with tray wagons, I like a lot the tray wagon, for big components we use it, but like AVFM we build our own pallets, and some of them were big 3x30 array or even bigger all pallets were done in a ESD mater
Electronics Forum | Mon Jul 07 21:33:15 EDT 2014 | andrespena
The problem about covering it with glue (without using solder) is that the components might dislodge by a miniscule amount underneath the glue. So maybe the contact points will disconnect. I'm not sure if this will be a real problem, but if so it wo
Electronics Forum | Thu Jul 10 11:24:27 EDT 2014 | spoiltforchoice
Use an oil free compressor ;). My UK based answer would be: We treat our air at point of use with a desiccant air dryer by Walker Filtration (this unit looks remarkably similar to units by Mark, Beko and others (especially the controller) this dryer
Electronics Forum | Wed Jul 16 06:54:36 EDT 2014 | alexeis
Hi, The answer is very complex depends on the type of machine, the operator's capabilities and process. There are machines that let you perform the above side then stick carts into the machine and produce. Event such a process is the length of a few
Electronics Forum | Wed Jul 23 18:14:46 EDT 2014 | warwolf
We have worked out as a guide formula to help us calculate this. As we have products that range from 5 unique pars to ~300 parts it is tricky to answer clearly. we worked out an average time to change our feeders at 3 minutes (this includes removin
Electronics Forum | Wed Jul 23 05:16:43 EDT 2014 | edriansyah
Hi All... Need your advice on the unit of measurement for solder paste pressure. My current company use SP machine from 2 vendor, both are using different unit of measurement. 1. Yamaha uom N 2. DEK uom Kg Up until now I dont know how to do