Electronics Forum | Wed Feb 18 12:15:30 EST 2015 | deanm
Try Precision Placement Machines (goppm.com). I bought squeegees from them in the past. They might carry new or used. I am in no way affiliated with PPM.
Electronics Forum | Thu Nov 05 20:53:37 EST 2015 | shuttlestar
It's a strange task . if your PCB is very very small ,using topside heat is not a big problem . but for a whole PCB board . if delete the step of preheat, it will broke the whole PCB . BTW,do you finish your task ?
Electronics Forum | Wed Feb 25 11:47:09 EST 2015 | emeto
What are the chances for redesign the board or use substitute for the current tall part? Sometimes the hassle you want to go through could be avoided. How about change the box the device goes to or modify/ customize it to fit this part better in?
Electronics Forum | Fri Feb 27 10:31:59 EST 2015 | mdang
We bought a use IP3 and we want to make adjustment in Y direction of the MFU. Is this proper setting or Mechanical calibration? Thanks, -Michael
Electronics Forum | Tue Mar 03 02:39:56 EST 2015 | sarason
I would presume you reflow the top of the board first. Use tented vias. As you have worked out, vias have surface tension, which sucks the solder up the hole during reflow of the bottom of the board. Good luck! regards sarason
Electronics Forum | Tue Mar 03 09:37:54 EST 2015 | capse
Hot bar soldering or hot bar bonding with ACF is widely used for your applications. A company I represent can assist you; Fancort Industries.
Electronics Forum | Wed Mar 04 10:24:50 EST 2015 | grenier
I'm looking for laser marking equipment for direct serial number Id on PCBAs. Is it recommended to laser mark on solder mask or copper or raw material?
Electronics Forum | Thu Apr 14 03:52:23 EDT 2016 | steve Wu
Hi,this is Steve from Chinasky Laser Technology Co.,Ltd.focusing on laser marking machine and laser welding machine.I'd like to make a discussion on laser issues with you,when it necessary.My skype:stevewu11.
Electronics Forum | Fri Mar 06 11:08:02 EST 2015 | burb1999
Looking at the FUJI AIMEX-II anyone have any experience with this machine, pros/cons etc? thoughts? Todd
Electronics Forum | Mon May 04 10:02:10 EDT 2015 | erinkou
Thanks for sharing with it. I also use it for my PCB orders. And now I recommend http://www.pcbway.com/e, it is a good Fab in China