Electronics Forum | Thu Jul 30 16:38:40 EDT 2015 | lokit
There are several big competitors out in the field. Since a few years 3D AOI is getting more and more populair. The reliability is much higher compared to comparing grey scales (pixels) with one another. Measuring the height, length and width of a co
Electronics Forum | Sat Nov 02 11:38:02 EST 2002 | fastek
Frank- Your point about the OEM's trying to help a small company with thoughts of bigger and better things in the future is a valid point. I've had that same argument with the OEM's for years but for different reasons. You're still missing the poin
Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Thu Aug 25 15:18:43 EDT 2005 | manish
Don, I have experienced the same thing as Russ. The fixed head systems do give the best uniformity (due to no overlap). Both Nordson and Sono-Tek offer fixed head machines that work excellent. I think the Sono-Tek system that Russ is refereeing t
Electronics Forum | Sun Apr 09 06:31:04 EDT 2023 | kumarb
I can speak from the Yamaha YV88X side (aka Emerald-X). We are an engineering company and recently started to use our SMT line. Absolutely love it and can run the machine with ease. Have assembled thousands of boards since COVID started. It is an old
Electronics Forum | Mon May 03 16:39:44 EDT 2010 | jlawson
Thanks Larry We are loooking a bigger Vapor > machine which could soldered our big size > borad(600x600 mm)assembled with hundreds of > sockets and thousands of components. How about > IBL products? Anyone used before? You should also look at
Electronics Forum | Thu May 14 16:09:49 EDT 2015 | hottchkisu
Hi All, > > On occasion we see components that > have gone through pick and place and are slightly > misaligned. Currently, operators manually adjust > these misaligned components to prevent reflow > failures. However, I am wondering if this >
Electronics Forum | Wed Jul 24 01:53:58 EDT 2002 | Mike Konrad
Using ultrasonic technology to remove adhesive is normally not that difficult. I do not know who�s machine you are using (perhaps its ours). In any case, here are some tips for removing adhesives. 1. Heated wash chemistry works better than ambien
Electronics Forum | Wed Aug 30 09:56:37 EDT 2000 | NLykus
Hi Ramon, We have had this problem before on our Seho Wave Solder Machine. We are currently using a spray fluxer as well. By imersing the PCB into the flux you stated you are getting good results. What you need to do is check your spray patter
Electronics Forum | Fri Oct 08 17:03:03 EDT 1999 | Dave F
| Hi, | | Help! Could anyone help to enlighten me on this? | | Question: | | If I have a CSP/BGA package of size X by Y and the standoff gap between the component and PCB is Z, What is the maximum allowable Y/Z or X/Z that using a normal water cl
.gif)
