Electronics Forum | Wed Nov 27 09:51:08 EST 2002 | Claude_Couture
I have worked with 4c's for two years. The feeders are "tinker toys" with a mechanism that slips, so the pick-up has to be adjusted several times as the reel is used, especially with 13" reels. The worm gear was plastic on the steel shaft of the moto
Electronics Forum | Wed Nov 27 18:10:41 EST 2002 | andrewbrook
Quad4C's have their moments. If the price is right and you are aware of the machines limitations then you will be satisfied. The placement rate is slow, 1.2 seconds/chip. Don't buy any Quad if it has the CyberOptics Laser unit, the Quadalign unit is
Electronics Forum | Sat Dec 21 14:07:53 EST 2002 | No man land
cool Music soothens one's emotions. It should be > mild and not loud. No voice. Just > music...Solos. > > We have used this successfully > in our plant. Every hour we have a two minutes > break to give rest to our operators who use > microscope
Electronics Forum | Mon Dec 23 18:06:38 EST 2002 | jersbo
Tried and True is counting your components if there is any indication of loss... this is a great TOPIC... unfortunately there are many ways to lose components. Feeder setup,problems with a feeder while in the machine(IE mylar problems or wrong step)
Electronics Forum | Thu Jan 02 12:15:10 EST 2003 | Mike Konrad
Richard, With respect to the Resistivity of Solvent Extract (ROSE) test, the test solution is exceptionally aggressive. With the Zero-Ion for example, the test solution�s resistivity is 150 M-Ohms. Additionally, because test solution is made up of
Electronics Forum | Fri Jan 10 00:56:53 EST 2003 | fastek
You really must be on a tight budget since most people will pay YOU to take these models off their hands. What is your budget for capital equipment? Zero? That said, I think you would be better served to step up a generation and look at MPA-3's inste
Electronics Forum | Thu Jan 16 03:43:42 EST 2003 | johnw
1st off for the forum folk, I don't like the fact that the new system only let's you see the posting your replying too, I'd rather be able to see the thread..... Anyhoo, why this alloy?, it's because it's the device manufacturers preferred and the c
Electronics Forum | Thu Jan 23 14:19:56 EST 2003 | Mike Konrad
Hi Randy, No-clean flux needs to be activated in order to burn off the volatiles in the flux. This normally occurs partly during preheat and certainly during the reflow or soldering process. In most hand soldering applications, an operator applies
Electronics Forum | Fri Jan 24 11:45:58 EST 2003 | Randy Villeneuve
I am not familiar with your flux but with no-cleans (which I use) the primary cause of icicling is the amount of flux solids left on the board prior to wave and how long the board is in the wave (2.5 to 3.5 seconds should be OK). The amount of flux s
Electronics Forum | Tue Jan 28 18:38:36 EST 2003 | joeherz
Mike, I've tried the high side of the flux preheat spec with no success. I did just get off the phone with Electrovert tech support...... Get ready. This machine is configured with a Contour Plus N2 nozzle. We are not running N2. According to M
We are a global electronics manufacturing Solutions provider ....Our company supplies new and used SMT equipment, spare parts, consumibles, ESD supplies and services to a wide range of EMS companies.
Equipment Dealer / Broker / Auctions
Parque Industrial Nogales No. 5297 Zapopan
Jalisco, Mexico
Phone: 523316044491