Electronics Forum | Wed Oct 29 23:07:42 EDT 2014 | rajz
Help Needed. I face a solder bridging issue on solder mask define pad at edge only for nexlev connector . The pad design such as smd at four corner only. The bridging happen on signal to ground pin only. Current stencil we use 22 round with 6 mils s
Electronics Forum | Thu Nov 13 12:49:45 EST 2014 | dyoungquist
I have no experience running a "move the board" selective solder so can not compare the 2 methods..... We have been using an RPS Rhythm "move the pot/nozzle" system since 2008. We are using it solder thru hole components onto boards that often have
Electronics Forum | Fri Dec 05 05:02:27 EST 2014 | sarason
When I was a younger man with a younger mans eyes it was easy to outplace a hand placement machine. Good hand eye co-ordination is all that is required now I would find it easier to use the machine , but my fine motor skills are still just as good. A
Electronics Forum | Wed Jan 13 03:56:30 EST 2016 | pcbgogo_downey
My job is manufacture the custom PCB boards, as I know, most of our customers use Eagle. It's really common use. You can dig internet for more information about this tool. Or you can try frizing, EASYPC,KICAD or other tools. You can check which one i
Electronics Forum | Mon Jan 12 08:02:06 EST 2015 | donb_68
I am interested in seeing de-panelization routers from ASYS and CTI in action. I am particularly interested in the Divisio 5100 and Divisio 2100 series routers from ASYS and the AR2020 and MR2 series routers from CTI. For the manual machines I would
Electronics Forum | Fri Jan 16 16:01:31 EST 2015 | emeto
GSMs are great machines for many parts, but for the small parts you should look for something better and more contemporary. As it was mentioned in one of the previous posts, the feeder is a big key. I don't think there is feeder for GSM that can supp
Electronics Forum | Fri Jan 16 16:57:14 EST 2015 | dilogic
I doubt you will be able to get satisfactory results with 0201. 0402 is another story. When doing 0402 projects, we use only electric (MP) feeders and always at the same feeder slots (feeder teach done for each of them). MPF08 nozzle works fine. Also
Electronics Forum | Tue Jan 20 04:43:33 EST 2015 | gragal
I need to replace a device which is in a 6-pin package which looks like SOT 23-6 / SC-74 style. The markings are D102/ 214B (D102 above 214B). I have checked numerous references to no avail. I think that the device is a comparator or op-amp with V
Electronics Forum | Tue Feb 17 09:37:16 EST 2015 | charliedci
We made the same change a year ago, from foam to spray fluxer. One of the reasons we changed, to keep the acid number within specs (foam fluxing) we had to measure once or twice a day and add DI water to make up for evaporation, all along not able to
Electronics Forum | Wed Mar 04 10:23:03 EST 2015 | rgduval
I haven't used this particular CC, but...found this in their data sheet: "AVR 80 BA Conformal Coating will be touch dry after 15 - 20 minutes at room temperature and does not require a thermal cure. The full properties of the coating will be obtaine
Buyer, Seller, Broker of Electronic Assembly Equipment
Equipment Dealer / Broker / Auctions
309 West Pickle Alley
Rushford, MN USA
Phone: 507-864-7477