Electronics Forum | Tue Jan 29 09:41:52 EST 2008 | d0min0
Hello, we use DataPAQ 6 slots - but after tech guys finally killed their profiler on wave its theirs now last year we used SolderStar neptune, 3-9 slots, but it is too easy to destroy it (4 times in repair...) so finally I started to use SlimKIC 2
Electronics Forum | Fri Feb 08 03:54:37 EST 2008 | muarty
I would think that you could quite easily use 0.6mm I/D nozzles even when using a hand syringe. As you say you are only using this for larger devices to prevent them from falling off. I am sure there are very reasonably priced small compressed air un
Electronics Forum | Fri May 02 09:35:20 EDT 2008 | toddl
Hi everyone, I am looking for positive and negative feedback on the use of the paste dispensing system on MPM screen printers. We currently have four machines with this capability that we do not use. Our printer operators insist that the dispensing s
Electronics Forum | Fri Jun 13 08:49:19 EDT 2008 | leemeyer
We use Zebra printers 170xii. If you buy used you can get them for a relatively low cost ( couple hundred $$). You will need to find software to work with the printer. We use Bar One. Brady Labels supplies a full line of thermal printable labels & ri
Electronics Forum | Thu Jun 26 13:55:56 EDT 2008 | dyoungquist
Water will not remove no clean flux residues because they are not water soluble. Solder paste with no clean flux should only be used when the assemblies do not need to be cleaned. That said, you can buy special cleaning solvents specifically for re
Electronics Forum | Tue Aug 12 08:35:28 EDT 2008 | avalancher
Many years ago... my old engineer used a very simple unit bought at Radio Shack. It was a device that they use in door ways to announce someone was entering the store. It used a beam of light and when the board broke that beam, a bell/ring/noise wou
Electronics Forum | Fri Dec 05 14:45:39 EST 2008 | wrongway
I have an 1 year old advantis with flexjet 3 head I tried using the on the head cameras with little luck using the upward looking cameras and putting the part defanition as a QFP using gull-wing leads mesuring the part as is seem to work best thats w
Electronics Forum | Thu Jan 08 12:43:31 EST 2009 | davef
Here's few more ideas: * Have vending machine vendor turn off advertising lights * Turn-off photocopier at night * Switch off all unnecessary lights * Use dimmers, motion sensors, or occupancy sensors to automatically turn off lighting when not in us
Electronics Forum | Thu Jan 22 03:25:26 EST 2009 | stevewilde
What masking tape can people recommend for masking the board when conformal coating. I am using a PVA autocoat machine and humiseal 1B31. Current tape, is leaving residue on board when used to hold link wires down whilst glue cures and also when used
Electronics Forum | Tue Jun 16 08:36:24 EDT 2009 | bocci572
We are looking into using a splicer for our SMT production area. I was wondering if anyone has any recomendations for a good splicer or splicing kit that can be used to splice our reels. I am looking for something that is easy to use and does not t
We are a global electronics manufacturing Solutions provider ....Our company supplies new and used SMT equipment, spare parts, consumibles, ESD supplies and services to a wide range of EMS companies.
Equipment Dealer / Broker / Auctions
Parque Industrial Nogales No. 5297 Zapopan
Jalisco, Mexico
Phone: 523316044491