Electronics Forum | Tue Jun 11 15:56:43 EDT 2002 | mjabure
Actually F4G is a programming environment similar to panatools, not a machine, it stands for "Fuji 4th Generation". The connection being questioned is to the communication network, and yes with the proper hardware you should be able to connect more t
Electronics Forum | Tue Jun 18 10:42:17 EDT 2002 | Boardman
Just wondering what criteria you used to come up with Junki? Direct experience? Last I checked Juki had the lowest annual spare parts costs of the major suppliers. Not what I'd call junk.
Electronics Forum | Wed Jun 12 22:35:03 EDT 2002 | jkhiew
We had alot of problem with melf diode short together after reflow soldering. The clearance is about 0.8mm & we used "v" shaped opening . PLease comment !
Electronics Forum | Thu Jun 13 05:46:34 EDT 2002 | jax
After reflow, Are the end terminals of the melf packages touching or is it a paste bridge? What type of reflow are you using? IR?... Convection?
Electronics Forum | Fri Jun 14 13:19:15 EDT 2002 | mjabure
The first question is, is this a high mix, low volume environment or vice versa? If it's the former then Kens solution is something you might want to look into. Depending on your feeder set up you might check to see if your operators have been traine
Electronics Forum | Tue Jun 18 13:22:53 EDT 2002 | gwaco
Hello all, I support the floor issues and it seems that a vast majority of our connecters always place off in the x or y. We are using IP3's with unicam software. Has anyone else run into this and what was the fix. Thanks Greg
Electronics Forum | Mon Jun 24 13:10:07 EDT 2002 | Sherry E. Howard
I was reading an article on reflow soldering of through-hole components today under the "knowledge base" section. I would like to hear from any of the SMTA members if their company is presently using this approach and their success. I would apprecia
Electronics Forum | Wed Jun 26 09:17:55 EDT 2002 | davef
We've talked about it a fair amount here on SMTnet. Search the fine SMTnet Archives for background. People use a variety on names to talk about this. Common names are: * Paste in hole [PIH] * Pin & paste
Electronics Forum | Tue Jun 25 12:08:14 EDT 2002 | kenbliss
I am curious what the identifications tags actually do. bar code, p/n etc. Are they for in process use or do they ship with the board. Why a tag rather than printing the info on the board.
Electronics Forum | Tue Jun 25 13:26:53 EDT 2002 | cnotebaert
Inernal use only, mainly for test fall out. We have a 3"x4" tag that gets attached. This tag identifies reason for fail and follows the brd until it is repaired, the tag is then removed and info is logged under the assy p/n & serial number.
We are a global electronics manufacturing Solutions provider ....Our company supplies new and used SMT equipment, spare parts, consumibles, ESD supplies and services to a wide range of EMS companies.
Equipment Dealer / Broker / Auctions
Parque Industrial Nogales No. 5297 Zapopan
Jalisco, Mexico
Phone: 523316044491