Electronics Forum | Sun Mar 26 20:14:12 EST 2000 | dave
I'm looking for a extension arm to fit on a Zevatech 8mm feeder which will allow us to use a 13" reel instead of the standard 7" reel. Does anyone make these or will I have to buld my own???
Electronics Forum | Mon Feb 14 14:46:42 EST 2005 | russ
We use Samsung and our 24mm feeders have 8,12,16,and 20mm pitch settings. I have found 20mm pitch quite common. My favorite is yhe 12 on 12 our feeders don't support that, we have to put them up on 16mm feeders our cycle them 3 times on a 4mm pitch
Electronics Forum | Mon Feb 14 17:36:37 EST 2005 | griinder
WE ARE USING MIRAE MX240. ON THIS MACHINE, THE FEEDER ADVANCE AND THE FEEDER PITCH IS CONTROLLED BY THE MACHINE/SOFTWARE AS OPPOSED TO THE FEEDER ITSELF. OUR SELECTIONS FOR 24MM FDDERS ARE 4,8,12, 16, AND 24MM.I WAS WONDERING IF THE 20MM PITCH WAS UN
Electronics Forum | Tue Feb 15 18:48:10 EST 2005 | russ
Tell me more about the C5! I thought we were talking used Vettes here
Electronics Forum | Mon Nov 18 08:38:46 EST 2019 | davef
Go to the SMTnet "Used SMT Equipment" page [ https://smtnet.com/mart/index.cfm?fuseaction=rfq ] and submit an RFQ
Electronics Forum | Mon Jun 29 15:45:20 EDT 2020 | spoiltforchoice
Yeah my issue with the CLM945 type single slot feeders used for parts over 6mm is they index forwards using a tiny servo attached to some gears that pull on the cover tape. A system that begs to fail, the tape can stretch, the gears can start grabbin
Electronics Forum | Mon Jun 29 15:10:10 EDT 2020 | spoiltforchoice
I would specifically look at the FLX2011 models with a V for vision (they otherwise come with Cyberoptics laser alignment as standard, although that would also work if you are not inspecting BGA balls). They come with software that I think is called
Electronics Forum | Sun Dec 14 23:37:31 EST 1997 | Lioa
Tow used Mk1c chip shooters in good condition whith 140 feeders in China.About 10,000 USD.
Electronics Forum | Wed Jul 01 01:25:58 EDT 2020 | jmelson
> I think the main > issue is the bend radius you can apply to tape > with deeper pockets. Right, on my Philips CSM84, on the larger tapes, I don't thread the tape through the return slot, I let it play out the front of the feeder. The
Electronics Forum | Thu Feb 10 14:56:50 EST 2005 | jimdugan
The Mydata machine is a very good high mix low volume machine. If you buy from Mydata you will be better supported, than if you buy from a broker. I would recommend you buy the newer My series machine. The TP machine was a good machine but the My ma
Capital Equipment Solutions - SMT | PCBA | TEST
Equipment Dealer / Broker / Auctions
113 S Main Street
Lodi, WI USA
Phone: 6083431779
