Electronics Forum | Thu Jul 14 12:11:58 EDT 2005 | geb
The vacuum will pull the stencil towards it if there isn't a frame because the front and back of the stencil aren't being supported by anything. Can't you use a frame, they're only about �20.
Electronics Forum | Thu Jul 14 14:57:54 EDT 2005 | pr
I would put the tactile sensor back in the Vacuum nest so operators won't drop it in the paste. my biggest wish, pr
Electronics Forum | Thu Jul 21 11:13:11 EDT 2005 | Scott B
Have you tried running the machine in stepper mode (Ctrl+S). This will allow you to hold and view the machine at each stage of the placement cycle. This may help determine if it is false placement, vacuum or kiss-off. We find this useful when trying
Electronics Forum | Mon Oct 03 11:53:30 EDT 2005 | paulbendemire
Regarding vacuum levels, how do we check that? Can anyone suggest a procedure? Thanks, Paul
Electronics Forum | Wed Nov 02 13:50:15 EST 2005 | chunks
Yeah this isn't too bad, but running hoses thru a vacuum assisted board support makes set-up difficult.
Electronics Forum | Wed Apr 12 09:33:10 EDT 2006 | jdengler
We had a similar problem and needed to slow the cam speed. The surface of our component was rough so I suspect we did not get a good seal for the vacuum and the component was drifting on the nozzle after the camera. Jerry
Electronics Forum | Wed May 10 12:22:45 EDT 2006 | reg
Hi everyone, I am trying to evaluate the cost of buying new equipment. One of the concerns is blade holders, stencil frames and board vacuum tooling. How difficult is to change from Dek to MPM or viceversa without changing all our tooling.
Electronics Forum | Thu Jun 15 22:03:32 EDT 2006 | Frank
You are correct, the Hover Davis label feeder works on 'un-punched' flat carrier. Get a sample of your dots on the tape and send it to Hover Davis to see if their feeder will work for you. The Hover Davis feeder will peel the dot off of the tape so
Electronics Forum | Thu Jun 29 12:41:26 EDT 2006 | chrisgriffin
I once had a CP-4 that was not cutting the paper from the reel, and the paper was nocking off the parts. You could also check the vacuum at pick-up and placement stations. What kind of parts are they? It might be a good idea to calibrate the stati
Electronics Forum | Fri Aug 25 07:42:29 EDT 2006 | davef
Our sympathies about the ENIG boards. B:) So, you cut the end off the barrier bag, take 200 boards, heat seal the end of the bag and restock it, build the 200 boards and ship them, right?
Reflow ovens for automated SMT PCB assembly, specializing in lead free processing and nitrogen reflow. The best convection reflow ovens on the market.
4 Vreeland Rd.
Florham Park, NJ USA
Phone: 973-377-6800
