Electronics Forum | Tue Nov 30 18:33:05 EST 1999 | Brian W.
I have used Loctite, RTV3145, or Tak-Pak to secure the wire. As John said, the wire is usually secured to the board near the lifted lead, and usually at 1/4 inch intervals along the way. Brian W.
Electronics Forum | Tue Nov 30 11:05:37 EST 1999 | Bob Smith
Hi, Can anyone give me the name & address etc. of a lab that will section PCBs and analyze defects? Thanks. Bob
Electronics Forum | Tue Nov 30 11:43:02 EST 1999 | Wolfgang Busko
Where should this lab be, means where�s your place, you wouldn�t like to send your boards elsewhere on earth? Wolfgang
Electronics Forum | Tue Nov 30 16:14:27 EST 1999 | Glenn Robertson
Bob - Try John Maxwell at (719) 687-6911. I have seen him do some presentations at the trade shows. Glenn Robertson
Electronics Forum | Tue Nov 30 16:53:57 EST 1999 | Dave F
Bob: consider two thing: 1 Most board fabs have PCB sectioning capabilities 2 Consultants Council Matrix (http://www.ipc.org/html/fsresources.htm) lists consultants that may be able to help you. Ta Dave F
Electronics Forum | Sun Dec 05 22:51:56 EST 1999 | dreamsniper
Just contact any PCB fab near your area/country or wherever your manufacturing site is located and ask them if they could help you with your problems...they should be able to do that...
Electronics Forum | Mon Nov 29 14:35:03 EST 1999 | Mark D. Milward
We are in the process of researching and gathering information on establishing a zero-defect soldering program. I am sending for an IPC video on the subject. I am particularly interested in getting some direction and hearing from those of you in the
Electronics Forum | Mon Nov 29 10:35:32 EST 1999 | Jason Birch
Gentlemen, Can anyone recommend a stencil cleaner manufacturer? Are there any advantages to using ultrasonic vs. high pressure? I am also looking to clean misprinted boards with the machine. Thanks, J. B.
Electronics Forum | Sun Nov 28 20:30:51 EST 1999 | Greg H
What are the possible consequences when there's a flux entrapment (location: vias under components)under components during wave soldering? thanks
Electronics Forum | Sat Nov 27 14:24:25 EST 1999 | Francis E. Farrugia
One of the modules covered at undergraduate level at our University is Electronic Manufacturing. It would be appreciated if a copy of a video dealing with SMT assembly would be sent to: Ing. F.E. Farrugia Manufacturing Engineering Department Universi
