Electronics Forum | Fri Jun 12 15:24:13 EDT 1998 | Marcos Silva
I would like to know some place to support with a good training in SMT process in USA or Europe. Thanks
Electronics Forum | Fri Jun 19 13:08:48 EDT 1998 | Grant Petty
Thanks to everyone for your advice, it is not to much more to add, so I think I will include it with the pruchase, and if I need it later, then I will be able to use it. Thanks again!
Electronics Forum | Wed Jun 17 19:44:31 EDT 1998 | Eldon Sanders
Rob, I think the change over on the Quad QSP2 is about as easy and fast as it can get without swapping out the feeder bases. In a high mix environment I think it is worth looking at. Regards,
Electronics Forum | Wed Jun 10 11:21:04 EDT 1998 | Kelly Morris
Does anyone have any info./studies on what the percentage or PPM defect rates are for each part of the typical SMT process. Example: Screen Print = 45% of total defects Component Placement = 25% of total defects
Electronics Forum | Thu Jun 11 20:52:43 EDT 1998 | Dave Garfield
Kelly: Glad to see your name on the Forum. I believe I could find some date from my past life if you wish. Please let me know. Dave Garfield
Electronics Forum | Tue Jun 09 17:30:44 EDT 1998 | Yuan
If i want to set up an assembly line, what would be the approximate cost for testers? Appreciate any replies. Yuan
Electronics Forum | Mon Jun 08 19:29:53 EDT 1998 | Eric Jenkins
Looking for used 2 used peel force testers, and used SMT parts counters also. Please call me 1 801-956-0897 or email. Eric Jenkins
Electronics Forum | Thu Jun 04 21:04:31 EDT 1998 | Chiakl
I have just been assigned to look into the ionic chromotograhy test on our PCBA but I have zero knowledge. Could anyone help to explain what is this test about? Is it a) a destructive test? b) What is the measurement unit of this test? c) What is th
Electronics Forum | Wed Jun 03 21:35:25 EDT 1998 | Mike H
Looking for vendors of splicing tape for 8,12 and 16mm tape and reel. Any net sources?
Electronics Forum | Wed Jun 03 17:40:52 EDT 1998 | Dave F
What methods do people use to dress pads after removing and before replacing the BGA? We use solder wick and a soldering iron, focusing on not "dragging" the wick across vias. This is laborous and booring. Who has a better way? Dave F