Electronics Forum | Fri Mar 15 18:41:23 EDT 2013 | anvil1021
Wow, I didnt realize that there was .001" Kapton tape....we will most likely try that if i can locate some over the weekend otherwise early next week....Thanks, great idea...anvil
Electronics Forum | Sat Mar 16 15:53:44 EDT 2013 | duchoang
Can anyone help me to set and run " VOID CALCULATION " on YXLON Xray Machine. Thank you so much.
Electronics Forum | Mon Mar 18 10:38:25 EDT 2013 | babe7362000
We are currently having an issue with one of our Jot Conveyors. The speed knob is on all the way (high setting), and the conveyor moves too slow and does not pass the sensor in time. Is there anything I can adjust to make the speed faster? Thanks
Electronics Forum | Fri Apr 12 17:35:54 EDT 2013 | buckcho
Hello, try loosing up the belt. If they are too tight it can cause the conveyor to run slowly or even to damage the motor.
Electronics Forum | Wed Mar 20 09:54:11 EDT 2013 | patrickbruneel
Seal and peel would be the solution to your curing time problem. It’s a thermoplastic hot melt which air cures as quick as 30 seconds. http://www.interfluxusa.com/Datasheets-PDF/Seal-and-Peel-(DSRev08).pdf
Electronics Forum | Wed Mar 20 10:17:54 EDT 2013 | cyber_wolf
Don't have a CP7 but I think it has the same loader as a CP643. There are about 15 different sensors that have to be made for the loader and carriers to work properly. Are you doing dual board load ?
Electronics Forum | Wed Mar 20 19:19:23 EDT 2013 | vikkaraja
No I am running a single board. I already have checked few sensors that I thought might be the cause. Still no luck. I will contnue with my troublshooting. Please let me know if you think of anything that might help me with resolving my problem. Tha
Electronics Forum | Thu Mar 21 08:38:55 EDT 2013 | cyber_wolf
It's most likely one of those sensors. Go into your loader I/O and make sure they all change state.
Electronics Forum | Mon Mar 25 14:59:55 EDT 2013 | jimmyboz
Yes, he is correct, it is probably a sensor. That does NOT mean a sensor is bad, just that it has not been activated during a time limit or servo count. Watch what the last 2 or 3 things it does before the error.
Electronics Forum | Mon Mar 25 20:25:19 EDT 2013 | vikkaraja
Jimmy, thats the hard part. I wish I knew which sensor is causing it. There are so many sensors it's very hard to narrow it down to a specific one. I have not given up yet. Thanks,