Electronics Forum | Fri Aug 23 02:29:16 EDT 2019 | sssamw
It seems because the soldering area is not enough, so the wetting force is small to hold the switch, remember >0.08g/mm2 for each part as in IPC standard. So, anyway, you need increase the soldering area to reduce weight/area number to below 0.08g
Electronics Forum | Thu Jun 27 12:45:03 EDT 2019 | jmoote
We have two Topaz machines,and use them regularly. However, we have a board that contains a standoff and a large electrolytic cap, and one is 11.2 mm high, the other 13mm. Is it at all possible to modify or upgrade the Topaz to handle these parts?
Electronics Forum | Mon Jul 01 03:40:02 EDT 2019 | robl
Hi Janet, You could pick up an Emerald very cheaply these days, which is very similar except has 2 heads and can go to 15-17mm high. May be cheaper than trying to modify a topaz & vision system. Same software, feeders etc.
Electronics Forum | Fri Apr 17 18:39:20 EDT 2020 | kumarb
You will have to bit-copy the original hard drive contents as there are some hidden registry keys on Windows for their software. In our case, the loss of the motherboard coin cell battery resulted in the software thinking that the license had expired
Electronics Forum | Fri Jun 28 21:09:56 EDT 2019 | joseangulo
Hi everyone, So basically i have a Wave optimizer (Model: SW-op) And after it finish to take the information from the wave, It show L Contact Lenght 0.00 CM and R Contact lenght 0.00 CM Any idea what can i do to solve this problem? Thanks
Electronics Forum | Sat Jun 29 18:59:43 EDT 2019 | davef
You weren't clear on the type of gauge that you're using. Strain gauge load cells are the most common. These load cells have two gauges. The orientation of the gauges affects cell performance characteristics. * Temperature compensated: Temperature
Electronics Forum | Mon Jul 01 04:58:50 EDT 2019 | SMTA-David
Hi, I have been looking around for an 8 zone reflow oven with convection heating top and bottom and computer control for setting up and storing profiles. The Chinese company "Jaguar" have a couple of models at reasonable price that look like they wo
Electronics Forum | Tue Jul 02 04:12:06 EDT 2019 | directx995
Hello everyone, Here is the question: What is the maximum q offset which can be corrected on polarized component? This question is refereed to Machine/Process Management segment of PCBA. I rly don't get this question, can any1 help? Where should
Electronics Forum | Wed Jul 03 06:52:27 EDT 2019 | bobpan
Seems to be fighting to hold its position. 1. Check for anything worn out...possibly idler bearing/pulley and/or the belt. 2. Maybe it could use servo tuning...this may help but usually servo tuning is not that critical. 3. Clean the scale and the
Electronics Forum | Wed Jul 03 08:10:34 EDT 2019 | bobpan
The amp is mounted on the back side and is black. 4 total mounted for x and y axis.....swap the 2 that are y axis amps. If you have never servo tuned before on a quad machine you not going to be able to do it. There is way to many things that you nee