Electronics Forum | Fri Oct 18 00:44:56 EDT 2019 | Aqueous Technologies
I know you mentioned you use a Tech Spray product. We have had success with their "Wondermask" water soluble product. When using a chemical additive (saponifier) in an aqueous cleaning system we have not experienced residues. I hope that helps. https
Electronics Forum | Fri Oct 18 16:30:28 EDT 2019 | tey422
Check with the tooling house where you get the fixture from. They should able to help out on that subject. At least they should know have some idea where you can purchase TACSIL from. Tip: when you dealing with flex cable PCB, always ask tooling ho
Electronics Forum | Fri Nov 15 22:05:09 EST 2019 | alanyang
Flexible circuits assembly is different from rigid board assembly. For some manfacturers, fpc assembly are some things more painful because the assembly quality is unstable. Recommend to check and hope these 2 blogs are helpful. Flexible Circuit Asse
Electronics Forum | Sat Oct 19 03:59:13 EDT 2019 | robl
1) take the data from the pick & place machine - should be held in there somewhere in a file you could poll at certain times. 2) Barcode scannner reading the codes and storing them in a spreadsheet with time stamp 3) Take from the oven host PC if i
Electronics Forum | Fri Oct 18 14:35:13 EDT 2019 | tey422
If all other tools appear to be working fine, only the A12 is having the issue. You might have a faulty tool(not within original spec). As Bruce suggested, check the A12 tool itself to see anything abnormal. If it's brand new, you might need some lub
Electronics Forum | Fri Oct 18 15:58:42 EDT 2019 | tech1
3 different A12 tools and the same error could be a problem with the tool holder or a parameter. I suppose the locking tabs in the holder could be worn or bent and you could try removing one of the pins from the tool and setting it in a different loc
Electronics Forum | Fri Oct 18 16:40:32 EDT 2019 | tey422
Whenever you are not sure if a part is good or not. Try to use it on the 2nd machine which uses the same part to test it out. If it "test" part works fine on the 2nd machine then it would be ruled out as not the "root cause". In your case, you can t
Electronics Forum | Mon Oct 21 09:41:42 EDT 2019 | mendezt6
Update: -The A12 tools will install in the 2nd machine. -Modified an A12 tool to install in the A13 tool location. -The modified tool will install in the A13 location of the 2nd machine, but not the 1st machine. Check that the parameters o
Electronics Forum | Tue Nov 03 20:28:33 EST 2020 | williamrobbins
Yes, it is most likely the BIOS and Windows Time configuration. If you are familiar with how to switch to Windows Operating system mode and back it can be checked. Our displayed times are off but in ASM trace service the times are all accurate so I d
Electronics Forum | Tue Oct 22 21:24:02 EDT 2019 | richgreen01
Hi All I have the above machine and every day on start up i get the failed to initiate hardware message.I have been getting around this by re initiating the motor controllers and it is good to go after this.Does anyone know the causes of the initiat