Electronics Forum | Mon Dec 02 08:43:20 EST 2019 | scotceltic
What are people using out there for minimum spacing between vias ? We recently came across a PCB manufacturer that wants us to increase our spacing due to their process. Below is our current spec. that we follow. Spacing between via pad to via pad o
Electronics Forum | Thu Dec 05 02:15:12 EST 2019 | sssamw
IPC 2221B mentions a minimum clearance of 0.5 mm between adjacent holes. A drill-to-drill spacing of 20 mils is a standard value in manufacturer design rules. For small annular rings and pad-to-pad clearance, the minimum via distance is often defin
Electronics Forum | Tue Dec 03 02:58:43 EST 2019 | ellafromgenesis
We are a chip manufacturer in China for over 20 years. We've been working on chips and wafers for a long time and got pretty much experience. Anyone who have queations about production process? Any queation is OK. Or contact me through email yagzho
Electronics Forum | Tue Dec 03 04:44:52 EST 2019 | grimus
Hello, My X-Ray X-Tek Harrier 160 Xi has crashed last week. Do any of you have experience with this equipment? Do you know whether spare parts for this model is still available somewhere? (it's no longer manufactured). thanks for any help!
Electronics Forum | Fri Dec 06 02:31:34 EST 2019 | grimus
Thank you Robi, I tried. Officialy service answered that they are not supporting this machine. So I'm looking for alternative method. Maybe some of you still have this machine, or you know when I can get spare parts (perhaps somewhere in Asia they co
Electronics Forum | Wed Nov 11 11:50:19 EST 2020 | paulanderson
An update. I managed to resolve the issue by wiring my own :) got a friend with a UK spec MY12 to take pics of the internal connections of theirs and then hard wired ours to match - worked perfectly. message me if you have a similar problem and I ca
Electronics Forum | Mon Dec 09 16:05:22 EST 2019 | slthomas
All termination platings are not created equal (sic). Some parts put up more of a fight against wetting than others, and in those cases you really have to dial it in. It seems like that in most of those cases I end up reducing the temps in the midd
Electronics Forum | Mon Dec 09 21:00:39 EST 2019 | sssamw
Did you solve this issue? It doesn't much look like the flux dried out, ti should be across whole board and has much more same defect if flux dried out. Did you have failure ratio data to show the defect location, for example 10% at location A on bo
Electronics Forum | Thu Jan 02 08:04:06 EST 2020 | philc
You might want to try baking the LED's in an oven for 24 hours prior to build. We keep our LED's in a humidity cabinet all the time, as we have noticed poor solderability if they are left out for too long. This may be even more important when buying
Electronics Forum | Wed Dec 11 14:38:25 EST 2019 | slthomas
The one thing I haven't seen mentioned yet is developing the the control systems for the process equipment and materials. You don't want to mix up your solder paste, bar, and wire, and you don't want to cross-contaminate by using equipment (solderi