Electronics Forum | Thu Aug 12 14:08:59 EDT 2004 | pgarsoe
This forum is for free use for all. Some times you see a question that is raised that your company's product would be a solution. Fine, post a general statement to that effect and a reference to where they can get more information. BUT DO NOT USE TH
Electronics Forum | Tue Aug 17 10:44:44 EDT 2004 | cyber_wolf
Carl, That machine looks way expensive. We found a used Fuji microscopic jig for 3500.00 It came with the master jigs and master tapes. It doesn't have all the bells and whistles, but it does exactly what it is supposed to. John, I am curious as t
Electronics Forum | Fri Aug 13 18:38:47 EDT 2004 | russ
Your paste manufacturer will have the best guidelines for you. Different paste types and manufacturers sometimes/usually require a little bit different setup. I would also contact your printer manufacturer. As far as stencil concerns the larger/be
Electronics Forum | Sat Aug 14 08:43:17 EDT 2004 | davef
Russ makes good points. Your printer supplier can give good advice on machine setup also. We know we're printing well when: * Paste at least as big in diameter as your thumb is rolling across the stencil * Paste is filling the apertures * Squeegee
Electronics Forum | Mon Aug 16 11:20:09 EDT 2004 | soease
Hi, to profile any type of temperature process, you should try ECD products. I'm used to work with their tool called Super M.O.L.E. Gold, wich is a data logger for six thermocouples that you can run through a reflow oven, for example, and then you c
Electronics Forum | Mon Aug 16 20:22:54 EDT 2004 | Grant
Hi, Thanks for the info! In the software can you add solder paste specs and heat sensitive components and see where the profile sits against these fast? Measurement is the easiest part I think, but what I thinks harder is good software to analyze th
Electronics Forum | Fri Aug 20 11:34:11 EDT 2004 | soease
Hi Grant, sly again. I was searching for some infos about Auto-SIR, and I found something that may interrest you; Concoat, wich is the company who sells Auto-SIR systems, also has profiling tools and they seem to have a more powerful software to ana
Electronics Forum | Sat Aug 14 21:31:31 EDT 2004 | Daveylau
I'm currently working in a SMT factory in China. I'd like to know what preparation that I would need to change from leaded to lead free soldering. 1.Starting with the PCB production, things that I need to concern about are solder mask, Cu protection
Electronics Forum | Tue Aug 17 10:37:45 EDT 2004 | M.Enright
Some cracks are really obvious,straight down the middle of the capacitor.Some are slight hair line fractures which fail at ICT.In all cases seen,all cracks are through the centre of the cap.My worry is that there may be some which have fractures and
Electronics Forum | Thu Oct 21 04:21:55 EDT 2004 | siverts
Have been through this before and we resolved our problem as follows: 1.Make sure that the length of your board support pins on Your HSP is correct. On that machine the board support pins depends on the board thickness (+ - some tenth's of a mm). It'