Electronics Forum | Tue Jun 01 08:42:08 EDT 2010 | rgduval
I'm randomly having some motor move errors, as well. If you swap your MOT board, and the problem continues, you're down to a couple of problems. Could be that the motor is getting ready to die on you. Could be an encoder problem. Or, could be som
Electronics Forum | Mon May 31 11:08:28 EDT 2010 | padawanlinuxero
Hello I am having problems with the hydra camera, I start getting an error message saying that the camera couldnt look at the fiducials on the hydra, I went to the camera in service and turn it on to see the problem but I found out that the real pr
Electronics Forum | Tue Jun 08 17:12:42 EDT 2010 | flipit
Kic Thermal used Pyropel. Cut with a razor blade and glue together with a good Dow Corning high temperature silicone. You can buy Pyropel in various thicknesses. It is not cheap. $100.00 for a 24" X 24" X 3/16" sheet. You can buy at McMaster Car
Electronics Forum | Fri Jun 11 03:14:03 EDT 2010 | muarty
Thanks Dax, We currently employ a stencil aperture design pretty much similar to that you describe. And you are correct in what you say about the thermal demands almost dictating the allowable voiding level. We have suggested to our customer that th
Electronics Forum | Tue Jun 15 22:31:06 EDT 2010 | Mag10
Depending on the how you plug the via, the void level can significantly affected. If you have via plugged from the bottom side; i.e. opposite side of the component, you will see alot of void due to entrapped air in the via hole. I found work best wh
Electronics Forum | Mon Jun 14 10:23:53 EDT 2010 | pcrane
I have CCA that has a SN100C HASL coating that I am wave soldering with SbPb. I have mounting pad areas on the CCA that are masked with a pallet during reflow so they are not exposed to the solder. The mounting pads are turning gray in some areas of
Electronics Forum | Thu Jun 17 10:22:51 EDT 2010 | floydf
Last July I posted a query about reflowing leaded paste to gold plated boards, I wasn't getting a good reflow. The answer that seemed to work was dwelling the board at reflow for the maximum recommended amount of time. Would anyone have an opinion on
Electronics Forum | Fri Jun 18 12:40:09 EDT 2010 | stepheniii
Are you talking about mini stencils for individual components? If so we check here first http://www.circuitmedic.com/products/stencils.shtml I think circuit medic only has ones for parts they have done repair work for. Their selection is a bit unu
Electronics Forum | Sat Jun 19 08:07:39 EDT 2010 | fortunetech
If you want to buy a Juki machine or any machine for that matter, then be ready with money in hand and you set the price you are willing to buy at today. In my experience alot of Asian Brokers want your best price up front, and then tell you it's too
Electronics Forum | Thu Jul 01 15:12:16 EDT 2010 | siddharth
Thanks to all for their inputs. @Hexielectronics, I am now trying to assemble the board by attaching it to a frame and removing the frame while waving it. I plan to put the boards back on the frame after the board cools down. Could you explain more