Electronics Forum | Mon Mar 05 16:16:08 EST 2007 | Mark
Hello, We are having issue with one of the customer board. This is 10 layer PCB FR4 with black solder mask. Coating Ni/Au. Soldering leadfree. We are using 7 zones air reflow oven (zones top&bottom). We have bed solder flowing for this boards. T
Electronics Forum | Mon Mar 19 05:51:24 EDT 2007 | pima
Hello I made some test on different oven and problem still occurs. The only progress is that with diffrent thermoprofil ( Ramp to Spike instead of Ramp- Soak- Spike skewed components appears at 1 % of produced parts). With Ramp - Soak-Spike we have p
Electronics Forum | Fri Mar 09 12:41:56 EST 2007 | coop
I have recently been handed over the waving operation here, and am unclear on how to address our recent issue with our Wave. We are using AIM WS-715M Flux in a Foam fluxer, and are using AIM SN-100C in the wave. The problem is on several of the assem
Electronics Forum | Mon Mar 12 11:27:35 EDT 2007 | coop
I am not using a solder pallet, I don't think the problem is contamination related, because these parts are on some of our other assemblies, and they're being waved with no problems. The problem seems to be mainly on our panelized boards for some rea
Electronics Forum | Mon Mar 12 08:00:14 EDT 2007 | rgduval
It sounds like you may be thinking of two different test methodologies. What is required? Bare-bard testing, to verify pcb fabrication? Or populated board testing, to verify manufacturing? If it's bare board testing, the fab house should advise a
Electronics Forum | Mon Mar 12 09:25:16 EDT 2007 | rgraves
Our internal designers are employing SMT connectors that utilize a �PCB positioning boss� in conjunction with normal gull wing leads. The use of these devices is based on the advertised ability of the boss to prevent �mis-insertions� and assist in �
Electronics Forum | Tue Mar 13 08:04:28 EDT 2007 | Cmiller
We have used thousands of them with no problems. They will not aid in "connector retention" unless you have a shear force at exactly the right angle. This is an advertising joke. They will help with alignment of the connector. Open your holes up so t
Electronics Forum | Thu Mar 15 17:33:20 EDT 2007 | Darby
As you are new to this - start with lots of hair and slowly reduce. Start with one good person. Spend the money on someone who knows the process, can set it all up, (including air, power, alignment, calibration, programming, troubleshooting, stenc
Electronics Forum | Tue Mar 13 07:56:19 EDT 2007 | Cmiller
Since you got no reply, I will give it my best shot but we do not have a radial inserter because they are really expensive. I would start with Universal instruments. I think its http://www.uic.com. I think they still make them in New York. TDK and Pa
Electronics Forum | Fri Mar 16 23:38:36 EDT 2007 | mika
I don't understand so please explain in more detail. You say ~0.3mm shifted. In what direction is the paste shifted? is it shifted the very same directions on all panels? Only on this product or even with regular pcb:s? What is the size of the panel