Electronics Forum | Wed May 02 10:37:59 EDT 2007 | DG
We have 4 EVS machines in our facility. The operators like them, maintenance doesn't. The PM's aren't that bad it just that maintenance doesn't like doing them. On a few of the earlier machines we have if the operators are not careful they can get mo
Electronics Forum | Fri May 04 19:23:28 EDT 2007 | darby
System > Machine Config > Mechanical OP > Head 3 Spec = Vision. Data In > System > Machine Config > Mechanical OP > M Centering 1 = Yes If your Centering unit is a two stage unit then also set M Centering 2 = Yes You should then be able to roughly
Electronics Forum | Mon May 07 22:28:17 EDT 2007 | colormaker
radiant heat. 137c The hollis was a great machine. The one I had the prehead wass on or off there was no setting. The pot temperature guage was brocken so I had to guess and manually turn the heater on and off. The whole machine was covered with 1 i
Electronics Forum | Tue May 08 09:50:19 EDT 2007 | patrickbruneel
Hi Loco, Good point!! The good old glass plate works just fine as long as the conveyor or carriers have L shaped fingers. A glass plate is usually about a � inch thick (a lot thicker than the actual board). With L shaped fingers the bottom of the gl
Electronics Forum | Wed May 16 14:48:07 EDT 2007 | jdumont
We got a good deal on ours for around $100K new with not many options. For what its worth I visited Novastar's factory in Pa and was not happy with what I saw there. There were almost no static precautions taken, boards were stacked in cardboard boxe
Electronics Forum | Fri May 11 11:18:16 EDT 2007 | rgduval
Their response time here has been excellent. Then again, their main US office is only an hour away from us, so, that may skew my opinion of their response time. Cost is average. Around $120/hour, plus travel and parts. Registering is an issue. T
Electronics Forum | Mon May 07 15:46:45 EDT 2007 | Hoss
IEC 60601-1 is a UL regulatory standard for Medical Electronic Equipment. We recently ran the humidity pre-conditioning segment of this testing and have found electromigration repeatably in areas with hand soldered joints (remaining NC flux). IEC 6
Electronics Forum | Tue Nov 18 13:10:16 EST 2008 | andersenequipmentllc
I need a service manual for a Philips CSM84 type > PA1306/20. I have the PA1306/40 manual, if that > is any use to anyone. The 1306/20 was the last > model with analog servo amps and DC brush motors, > the 1306/40 was the first with AC brushless
Electronics Forum | Wed Nov 25 12:27:18 EST 2009 | andras
Here are the manuals: http://www.toldacuccot.hu/dl.php?sid=ea6f1feeba21ce26cb798edddc031c0f&file=CSM.part1.rar http://www.toldacuccot.hu/dl.php?sid=b6528b8ac0bdbbd3ee96f4f1e728e77f&file=CSM.part2.rar http://www.toldacuccot.hu/dl.php?sid=79db96a97060
Electronics Forum | Fri May 25 13:38:15 EDT 2007 | mfgengr
TAL Too Long - dull solder joints, dewetting. TAL Too Short - cold solder, insufficient wetting. You want TAL to be as short as possible (but not lower than 30 seconds), but long enough for every solder joint to be above TAL for at least 30 seconds.
