Electronics Forum | Wed Nov 07 22:03:50 EST 2001 | ericchua
Hi, I had a problem of how to convert from Torque (Nm) to pound. If I have a electric screwdriver with the spec. of 0.7 torque, what about pound. Can anyone help how to convert it. Thanks......
Electronics Forum | Thu Nov 08 09:59:43 EST 2001 | caldon
Here is a great web site to down load a cool conversion table: http://www.joshmadison.com/software/convert/download.asp To answer your question: 0.7N-m = .52lbf-foot Best regards, Cal
Electronics Forum | Thu Nov 08 03:12:12 EST 2001 | Tom
I want to know the standard of component footprints, especially the dimensions of those component footprints. Where can I find the information?
Electronics Forum | Thu Nov 08 11:55:45 EST 2001 | davef
Consider searching the fine SMTnet Archives. For instance look at the following thread: http://www.smtnet.com/Forums/Index.cfm?CFApp=1&Message_ID=18112
Electronics Forum | Fri Nov 16 10:22:51 EST 2001 | Steve
Try IPC-SM-782A,Surface Mount Design and Land Pattern Standard. Go to http://www.ipc.org
Electronics Forum | Thu Nov 08 17:45:36 EST 2001 | davef
The e-mail link in the following thread doesn't work. http://www.smtnet.com/Forums/index.cfm?fuseaction=thread&CFApp=1&Message_ID=18116
Electronics Forum | Fri Nov 09 09:17:49 EST 2001 | bdoyle
ok lets see. http://www.smtnet.com/Forums/index.cfm?fuseaction=thread&CFApp=1&Message_ID=18116
Electronics Forum | Fri Nov 09 10:25:43 EST 2001 | steven
is it all right to reflow a BGA using a rework station but without applying a layer of solder paste on pcb. the diameter of the solder ball is 0.75 and the pitch is 1.5mm.
Electronics Forum | Fri Nov 09 13:50:50 EST 2001 | Jim Hammes
Any good advice on techniques to properly coat BGA devices on a PCB? Our preference is to spray the boards but I wonder if the coating will do much good. Thanks Jim
Electronics Forum | Fri Nov 09 16:59:32 EST 2001 | davef
Dunno. What is your goal in coating boards? What material are you using? How thick are you applying this material?
