Electronics Forum | Wed Jun 16 22:33:52 EDT 2004 | Honorio Crespo
I will like to compare my average component placement per hour on a Fuji CP-6 versus other companies using the same machine. Can you share with me your average? Thanks, Honorio
Electronics Forum | Thu Jun 17 09:59:04 EDT 2004 | Sorin
I badly need a socket RS232 Modem, I couldn't find a supplier to deliver the sampels earlier than 2 weeks. Thank you for any iformantion.
Electronics Forum | Thu Jun 17 18:34:27 EDT 2004 | Eagle44
We once used a padded mesh in our board washer baskets to prevent damage to components. Can anyone tell me where I can find this material? Thanks
Electronics Forum | Wed Jun 23 17:49:39 EDT 2004 | Shean Dalton
Austin American Technology has had good experience with Stone Mountain Tool. Visit http://www.stonemountaintool.com or call 770-929-0166.
Electronics Forum | Wed Jun 30 15:06:01 EDT 2004 | waveroom
Yes the Plastisol is ESD Safe. Make sure when ordering you specify black esd safe plastisol. We probably would pick it up anyhow, but best to make sure.
Electronics Forum | Tue Aug 03 18:04:28 EDT 2004 | kmakiya
Thanks for the info. I have looked at an EVA mesh that will pass esd test as well as exposure to w/s flux and hot water. Stainless is great but the the softer material is what I want. I want to get samples of the thermoplastics from Mcmaster. Thanks
Electronics Forum | Fri Jun 18 13:49:11 EDT 2004 | Claude_Couture
We have those card rack locally made out of aluminium sheets. Same principle as the one you are using.
Electronics Forum | Fri Jun 18 13:58:38 EDT 2004 | russ
the conductive standup racks can be purchased from Fancort and are available through most distributers such as Contact East, Hisco, Future Active, technitool, etc...
Electronics Forum | Fri Jun 18 14:22:03 EDT 2004 | James
I like Trace Racks, part # GFR-4. They are simple and compact but may not be good for larger boards. Under $10 each. 1-800-358-1400
Electronics Forum | Fri Jun 18 11:36:55 EDT 2004 | jdumont
Does anyone have any experience using AIM NC298, or any new NC solder paste from AIM in general. I have no experience with AIM and would like to give them a try. Thanks in advance JD
.gif)
