Electronics Forum | Fri Apr 23 10:53:24 EDT 2010 | evertonsanches
Hello Sir, in this situation I recommend you to check and reconect the conectors of Quad Align Board and also of Quad Align Sensor. Everton - Brasil
Electronics Forum | Thu May 20 10:01:23 EDT 2010 | jmw
Just a slight correction....the quad align card is located at the back rear right of the machine (in a cage). If it is a cyber-optics 4c machine....the laser align card is in the front card rack to the far left.
Electronics Forum | Fri Apr 23 17:00:31 EDT 2010 | davef
Hegeman: So you receive these boards in seal moisture barrier bags, store them in a controlled environment, and use them as needed; what is your goal in baking these poor babies?
Electronics Forum | Sun Apr 25 09:10:25 EDT 2010 | sudhir14
Hi, pl. help me , I need details info. on Cp & CPk methodology , how to calculate , how to analysis Sudhir
Electronics Forum | Mon Apr 26 03:00:43 EDT 2010 | fujiphil
Check the following... 1. Set the fiducial reading to SCAN... 2. Clean the half mirror of the fiducial camera... 3. Check the CCD Camera...maybe blown fuse inside. Hope this will help.... Good luck....
Electronics Forum | Mon Apr 26 15:52:11 EDT 2010 | markhoch
If the above recomendations do not help...(I'd try them first) Did you try the infamous "Fuji Fix"? Power the machine all the way down and power it back up. (Rebooting the software)
Electronics Forum | Sat May 08 07:03:31 EDT 2010 | aj
From looking at your images I would say it could be poor solderability on the terminations of the component itself. Can you get your hands on a different date code and try them out?
Electronics Forum | Tue Apr 27 18:33:35 EDT 2010 | smt_guy
what IPC Standard do I need in designing RF Boards that pertains to PCB Layout, Conductor width and spacings, Trace thicknesses etc... thanks and best regards,
Electronics Forum | Tue Apr 27 20:12:42 EDT 2010 | davef
Look here: http://www.ipc.org/4.0_Knowledge/4.1_Standards/SpecTree.pdf ... that would get you to IPC-2252 - Design Guide for RF/Microwave Circuit Boards. Admittedly, it's not a standard, but that's what you get.
Electronics Forum | Wed Apr 28 16:30:04 EDT 2010 | cusackmusic
We use Quad IICs, and IVCs and love them. They can be expensive to fix, but they are pretty reliable. I think PPM is releasing Windows software for their rebuilt machines, although I think it was going to be exensive. Maybe they give it away with
