Electronics Forum | Mon Jun 02 20:38:42 EDT 2014 | davef
I believe that you get better responses when you start a new thread, but that's just an opinion, not a rule. BR ... davef
Electronics Forum | Tue Jun 03 08:49:06 EDT 2014 | patel_daxa29
Check out the set up of Depanelizer. Try to cut at slower speed & check the blades to make sure it is not time to resharp the blades. If all this parameters OK I would sustect lamination process of board house.
Electronics Forum | Tue Jun 03 19:28:06 EDT 2014 | hegemon
Maybe the V-Score is not deep enough? I am used to seeing more like a 30% remaining web, you are closer to 50% 'hege
Electronics Forum | Thu Jun 05 10:17:12 EDT 2014 | swag
Can you cut v-scores deeper to resolve the issue then build carriers to support the panel? I would say that we usually build carriers for anything that thin regarless of the depanel method.
Electronics Forum | Tue Jun 10 21:15:01 EDT 2014 | comatose
We had a similar problem once, it was due to insufficient v-score depth. While waiting for remade PCBs we would run an exacto knife along the score lines prior to depanel to cut a little deeper. Not ideal for sure, and not fast, but it worked.
Electronics Forum | Thu Jun 12 13:36:32 EDT 2014 | clydestrum
Deepening the V-scores was in vain. No change. This board is on Rev R now, with no changes to material/array/v-score spec, and this is the first we've seen this problem. I just don't get it.
Electronics Forum | Tue Jun 03 03:46:07 EDT 2014 | akasi
Is there a peelable solder mask which can withstand an automated aqueous wash ? I need to prevent water ingress into SMT modules during the wash cycle.
Electronics Forum | Tue Jun 03 10:30:36 EDT 2014 | cbeneat
We have the same ovens, our 2 sided boards have the same profile for both sides. Haven't seen a problem in 8 years.
Electronics Forum | Wed Jun 25 03:13:54 EDT 2014 | Kristof_K
Hi, > > Which dissipative ESD floor is the best > for an industrial usage? > > - vinyl - > epoxy > > Thanks Epoxy look much better and it was cheaper than PVC/vinyl. The surface isn't as smooth because fastidious to the smooth and horizontaly
Electronics Forum | Tue Jun 03 12:25:54 EDT 2014 | taiji
Hi Does any one know what is the min/max temp for material storing? I mean, for MSD once it is properly sealed in MBB, what will be the max temp to store in the ware house? Does any one know what is the standard for that? Thanks