Electronics Forum | Wed Jul 02 01:59:23 EDT 2014 | haiae
Yes, I can share you my expriences about Contact SMT placement machine. Just drop a message I'll help you to solve your problems.
Electronics Forum | Mon Jun 16 11:07:26 EDT 2014 | mdavister
Does anyone out there have a copy of the Technical Manual for the Zevatech PM560? I'd take either a hard copy or scanned in pdf.
Electronics Forum | Mon Jun 16 23:15:41 EDT 2014 | sarason
Try asking the question in the Zevatech Yahoo group. https://ca.groups.yahoo.com/neo/groups/zevatech/files sarason
Electronics Forum | Fri Jul 04 16:42:03 EDT 2014 | menvox
I have technical manuals for Zevatech PM560, I can make you a hard copy.
Electronics Forum | Tue Jun 17 00:19:10 EDT 2014 | jasmine01
When i send UDP packet of 1500 with DF=0, it's not forwarding to destination. How can do i to packet fragment buy Cisco 1941? Any clue ?
Electronics Forum | Wed Jun 18 02:43:37 EDT 2014 | tjbooc
CHECK IO BOARDS STATUS, CHECK HEAD IO 24VDC SUPPLY, CHECK 24VDC SUPPLY TERMINAL, CHECK WIRING CONNECTED TO HEAD IO I think this is an I/O communication problem. Fail in connecting to I/O cards.
Electronics Forum | Thu Jun 19 12:28:21 EDT 2014 | jdengler
I think his units are wrong. We did a very thin board with some 0805 resistors on it at 80 cm/minute. This generated a profile a little over 4 minutes. Regards, Jerry
Electronics Forum | Fri Jun 20 07:16:00 EDT 2014 | jdengler
Hi Edri, Unless there is something wrong with your conveyor there shouldn't be very much vibration. What little there is would not cause components to move around. Jerry
Electronics Forum | Fri Jun 20 08:41:19 EDT 2014 | cbeneat
We also run about 1.21 m/min on our profile, never had any parts shake loose.
Electronics Forum | Wed Jun 18 09:42:17 EDT 2014 | charliedci
We have an older Checksum with intermittent bootup problems. Factory does not support, looking for someone with knowledge or might know someone who supports these older systems. Thanks