Electronics Forum | Thu Dec 29 10:14:51 EST 2016 | swag
We use Access database. Works well but you have to custom build everything you want to track as it's not specifically designed for electronics mfg. You need someone in house who's good with that stuff.
Electronics Forum | Tue Dec 27 15:07:28 EST 2016 | luciano
Hello, Sorry for the mistake. The speed is 1m/min. We are using Alpha Vaculoy solder and a conveyor angle about 7º. We are not using pallets since the fingers hold the boards directly. Thanks!
Electronics Forum | Wed Dec 28 20:56:14 EST 2016 | anhsang38
Dear Pro, Pls, try to get solder's profile from solder supplier. That is the most important in wave soldering process... if not you will be difficult for improvement. Good luck.
Electronics Forum | Thu Dec 29 10:07:14 EST 2016 | emeto
Luciano, It looks you have no flux there. Please flux one board by hand and send it through the wave. That will eliminate a lot of the possibilities.
Electronics Forum | Thu Dec 29 11:18:31 EST 2016 | emeto
HEllo all, I changed a THERMOCOUPLE on my soldering pot. Now when I start the machine, pot shows 80C but it is over 300C. Any thoughts?
Electronics Forum | Fri Dec 30 10:24:02 EST 2016 | jdengler
Is it the correct type of thermocouple? If it is designed for a K type and you put a J or T the reading will be lower. Also a bad connection can give a lower reading.
Electronics Forum | Fri Dec 30 11:35:16 EST 2016 | emeto
Thank you all. It was a bad connection. Everything is running fine. Happy new year to everyone! Emil
Electronics Forum | Thu Jan 05 02:55:35 EST 2017 | soldertraining
I want to know the challenges facing the future of PCB in design and development. What solutions are possible for that?
Electronics Forum | Thu Jan 05 03:58:19 EST 2017 | rafaelnagares
Hello, I am having problem with the width of the conveyor and I suspect I need to calibrate this function. Do anyone have a Service manual? I have the operator and main software manual, but not service manual. Thanks a lot friends.
Electronics Forum | Thu Jan 05 04:03:56 EST 2017 | rafaelnagares
Hello, I am having problem with the width of the conveyor and I suspect I need to calibrate this function. Do anyone have a Service manual? I have the operator and main software manual, but not service manual. Thanks a lot friends.