Electronics Forum | Wed Aug 02 14:54:15 EDT 2006 | chrisgriffin
I mean if you are using the same stencil for the top and bottom of a board. Thanks to everyone for the help. From what I gather, it will work when the stencil cut-outs are offset from center in the Y-axis. Doesn't work too good in the x-axis, beca
Electronics Forum | Mon Aug 14 15:00:20 EDT 2006 | russ
I have used Martin, Metcal and Ersa. I would go with the Metcal. i thnk you get the most bang for your buck withthis unit. Martin service and support can be taxing on the Mind if you are in US. fairly decent unit though. would recommend if you l
Electronics Forum | Tue Aug 01 06:21:37 EDT 2006 | Rob
Hi, anyone in the UK using RAMTIFFs on their GSMs? we're having a clearout and have 2 spare, free to a good home. Also got 4 GSM feeder changeover/test trolleys - free as above. Rather they went to someone who is going to use them, than some one wh
Electronics Forum | Tue Aug 01 12:25:12 EDT 2006 | slthomas
Yes, I realize the odds of anyone having any experience with these things is limited but I have to start somewhere. Can anyone with knowledge of model TRM-SMD give me a holler? I have some questions about how they were set up at the factory, specifi
Electronics Forum | Tue Aug 01 15:02:06 EDT 2006 | BillB
Had a Treiber in a past live. Had a standard air knife in the first section and then a turbine blower with a stainless steel air knife with about 15-horse motor. Had some problems with bearing on the turbine Make sure the exhaust hot air doesn't con
Electronics Forum | Wed Aug 02 14:13:39 EDT 2006 | BillB
Sorry, can�t help much as my memory is getting dim. It seems that the first stage took place with a small blower after/during the time the board went thru a heater module. Can�t remember were the intake for this blower was. It seems to me that the
Electronics Forum | Wed Aug 02 06:03:16 EDT 2006 | jammy
Presently I am looking to buy either a PDR X410 or ERSA IR550A rework mahine.The PDR model is the favourite at the moment however I would not turn down the ERSA model or any other similarly specified infrared based rework system.Unfortunately I have
Electronics Forum | Tue Nov 21 12:15:05 EST 2006 | billwestiet
From a used guy: See http://ietechnology.net/ietechnology.net/show_inventory.asp?id=Rework%20Stations or browse at http://www.ietechnology.net Where are you located, it always seems that the used market on certain products is better in some areas tha
Electronics Forum | Mon Dec 04 16:55:58 EST 2006 | Rog
Hello Dougs and Steve (the message before) I am the R from PDR. Sitting here in England browsing. Thanks for your comments. In the end, all the technologies work to some degree...but as you have found out, we have some good points. It has been 20 ye
Electronics Forum | Thu Aug 03 09:05:09 EDT 2006 | Rob
We used to do point to point through hole soldering with robots. OK for medium to large volumes, but we did have to develop customer holders for each product. Quality was good - every joint was programmable for tinning, preheat, temperature etc, a
