Electronics Forum | Tue Jun 01 03:51:05 EDT 2010 | aj
Hi, just enquiring about Vmanage offered by Mentor graphics as a factory management solution or any aletrnative. I have carried out some research on line but would like to hear from some users before I contact the supplier themselves. Any info grea
Electronics Forum | Wed Jun 02 11:58:20 EDT 2010 | palsingh
TDK RX-11 giving Absolute Encoder Backup Error (237-100) at start up. The machine resets pressing the button but gives X and Y axis hardware error while doing zero position. The X and Y axis does not even jog manually. I followed the manual instructi
Electronics Forum | Fri Jun 04 02:51:25 EDT 2010 | tomta
We have a DEK 265 printer currently down due to the rail system error. The message "Belt Motor Error. Rail lifted error, check tooling" pop-up when pressed run. I did remove all the support pins prior loading a new job. I also ran rail system dian
Electronics Forum | Sat Jun 05 09:24:40 EDT 2010 | dekhead
As stated, that error relates to rail lifted sensord (L & R)... Machine is perceiving that something is causing rails to lift at inappropriate time. You can monitor sensor status in Rising Table diagnostic to see that they are toggling appropriately.
Electronics Forum | Fri Jun 04 16:30:10 EDT 2010 | jdm2008
I am running a cemelot 5000 and I am having trouble with the solder clogging up the needle. When the solder is removed it almost appears if it has reflowed. I am using a 22 guage needle, and the problem occurs with both type 3 and type 5 solder pas
Electronics Forum | Sat Jun 05 14:20:10 EDT 2010 | davef
It's a common problem. Try using a different needle diameter. Paste type||Suggested needle size II||21 or larger III||23 or larger IV||25 or larger V||27 or larger VI||30 or larger Additionally, improper clearance between the auger pump screw and t
Electronics Forum | Tue Jun 15 19:14:51 EDT 2010 | hegemon
You also need to consider the total metal load in your dispensable paste. You'll need a slightly higher flux content and less metal, say around 87% total metal, in a 4 or 5 mesh size. We had to have some special mixes made in order to do fine pitch
Electronics Forum | Tue Jun 08 16:27:29 EDT 2010 | eezday
what type of turn times are you requiring? I don't want to get too far away from your topic but I want to suggest that it might be easier to continue your search for a fast turn manufacturer then it is to embark on the arduous task of putting togeth
Electronics Forum | Tue Jun 08 18:25:47 EDT 2010 | smtmax
Hi Danny, Are you doing lead free? If yes, I would consider the AE-R330A or SMT-2010 lead free reflow oven. Our reflow oven is affordable and brand new. Just want to make sure what size is your board. Also, all of our equipment comes with one year s
Electronics Forum | Tue Jun 08 19:13:03 EDT 2010 | vmorina
Hi Vee, I thank you very much for the reply,and yes everything is ROHS. I am reading over the manual and looking at the differences between them. I also have a questions for you regarding stencils for BGA and other types of packages. Do you know any
