Electronics Forum | Thu Aug 16 04:35:10 EDT 2012 | craigweir
Can anyone advise on the risks involved in using a (previously soldered) component, in this case an 'SOIC8', as pick-up area for subsequent pick/place operation of sub-assy to larger motherboard ? The sub-assy in question would be a small outline(25
Electronics Forum | Thu Aug 16 11:15:38 EDT 2012 | menatech
delete the pointer readings.dek. If the printer loads after restart is the problem a corrupt program (last printed product. if this not work could it be a problem with the DEK config file. save the the file on floppy and delete it from the m/c. the s
Electronics Forum | Mon Sep 03 04:05:56 EDT 2012 | omur
The issue has finally been resolved. It turns out that while checking the vision board, our engineers accidentally changed the address of the Analogue Board (which is adjacent to the vision board) - thus, leading to this startup error - with the unh
Electronics Forum | Fri Sep 14 10:30:45 EDT 2012 | dekhead
I believe there was a software issue as well; Initially installed software (4.03) replacing existing 2.12. After that it got past the "Stack Overflow" and displayed the expected error for incorrect addressing on PCAD12... BTW solution to "vision boa
Electronics Forum | Mon Aug 20 22:02:23 EDT 2012 | davef
Try: * CheckSum LLC, 6120 195th St. NE, Arlington, WA 98223; 360 435 5510 877 CHECKSUM F360 435 5535 checksum.com * Testronics, 903 N. Bowser Road, Suite 300, Richardson, Texas 75081; 972-542-3111 testronics.com
Electronics Forum | Sat Aug 25 11:54:48 EDT 2012 | dan_ems
Hello, I already build such a system with hardware and software from National Instruments. I think is the best solution because you can buy for the start only a Multimeter (DMM), a multiplexer and a software. Is very easy to do the programming but
Electronics Forum | Mon Aug 27 08:16:23 EDT 2012 | rway
No, in his case an ICT in not out of the question. An ICT, especially with many passive components, can give you piece of mind that the assembly was built correctly. Even with the addition of an automated insertion machine, you still run the risk o
Electronics Forum | Sat Aug 18 10:06:05 EDT 2012 | cyber_wolf
There is no defined method that I am aware of. If your bulbs are old replace them. Other than that adjust the gain and offset until there is clear definition on the edges of the components. Keep an eye on the dump box.If the dump box stays relatively
Electronics Forum | Sun Aug 19 07:59:06 EDT 2012 | processman
Thanks for the replies guys. Interesting the one with the dryer in the air supply, will look into this. Sure some of our service guys lightly grease the O rings within the spindles, have been trying to get them away from this. Also interesting to h
Electronics Forum | Tue Aug 21 13:24:50 EDT 2012 | cyber_wolf
As a side note: A lot of machine manufacturers call out IPA as a "degreaser". As an experiment put a dab of grease in a container with IPA then put some in a container with mineral spirits. Shake them up and see which one dissolves the grease. It's