Electronics Forum | Thu Aug 13 14:43:23 EDT 2015 | alphatronique
HI i try to figure how the "Manual load adapter" work on a T3 Table machine ? seem that the table always try to move the board to the the left sensor location ,but if i use the magnet manual table it will never find the board on the table convey
Electronics Forum | Mon Aug 17 11:29:41 EDT 2015 | deanott
Thanks for the useful instruction. We did find a loose connection. It was the connector right at the camera/PCB. I believe it was bumped when placing board supports (going forward we'll move the camera to the rear when placing board supports).
Electronics Forum | Fri Aug 14 00:36:55 EDT 2015 | bideas
Hi, I recently purchased a used Manncorp S-2000, which is a rebranded Samsung CP20CV. I can't get into the System Setup menu without a password and the included manual is no help. Does anyone know what the default password might be? Or if there i
Electronics Forum | Thu Aug 27 09:58:45 EDT 2015 | fcmtechnician
Hi Take out the steel plate, is acting like a trampoline, oscillating with the machine movements! Is the machine leveled OK? The installation guys use 0.02/1000 Spirit Level ( leveler )? Let the machine on the concrete floor, try first on the top o
Electronics Forum | Fri Aug 14 09:40:59 EDT 2015 | jvalverde
Hello, I want to make a simple conformal coating machine, I think in a Cartesian robot with MACH3 software. My questions are about the G-Code for the program (the software to design: % open/close nozzle, the paths (trajectory), import the pcb fi
Electronics Forum | Thu Aug 27 10:12:07 EDT 2015 | fcmtechnician
Hi buy a manufactured machine! is not hard to build one, but the know how after you build it is the key point for you! Are you able to build and control the applicator to coat your board? are also some Budget machine on this area, look for Dima, Ca
Electronics Forum | Thu Sep 10 17:13:31 EDT 2015 | tombstonesmt
There are factors that manufacturers have taken into consideration when dealing with coating. On/off times, dispense speeds, heights, etc.. Dedicated software with tools to easily map out paths are a godsend. We made our own coating machine with a s
Electronics Forum | Fri Aug 28 11:11:28 EDT 2015 | dlee87
I may have what you are looking for but it is a > 244mb file. Hi! Sr.Tech Can you put the file into a CD and send to us, we'll pay for it!!! Thank you very much Daniel Le ESC Maintenance Tech
Electronics Forum | Fri Aug 21 07:06:36 EDT 2015 | scotceltic
Thank you for the feedback. Yes we run many different products. We also have many different product variations that run the same PCB therefore the strong possibility if we have the wrong program loaded it will still run through the equipment. This
Electronics Forum | Wed Aug 19 16:28:03 EDT 2015 | mdeley
Looking for a Santa Clara area contract service with capability to attach 15mil dia. solder coated Cu balls, ideally on a 12" x 18" PI panel, small job to start. T&R services are a plus. My initial search is coming up with device/component level r