Electronics Forum | Fri Oct 18 15:58:42 EDT 2019 | tech1
3 different A12 tools and the same error could be a problem with the tool holder or a parameter. I suppose the locking tabs in the holder could be worn or bent and you could try removing one of the pins from the tool and setting it in a different loc
Electronics Forum | Fri Oct 18 16:40:32 EDT 2019 | tey422
Whenever you are not sure if a part is good or not. Try to use it on the 2nd machine which uses the same part to test it out. If it "test" part works fine on the 2nd machine then it would be ruled out as not the "root cause". In your case, you can t
Electronics Forum | Mon Oct 21 09:41:42 EDT 2019 | mendezt6
Update: -The A12 tools will install in the 2nd machine. -Modified an A12 tool to install in the A13 tool location. -The modified tool will install in the A13 location of the 2nd machine, but not the 1st machine. Check that the parameters o
Electronics Forum | Tue Nov 03 20:28:33 EST 2020 | williamrobbins
Yes, it is most likely the BIOS and Windows Time configuration. If you are familiar with how to switch to Windows Operating system mode and back it can be checked. Our displayed times are off but in ASM trace service the times are all accurate so I d
Electronics Forum | Tue Oct 22 21:24:02 EDT 2019 | richgreen01
Hi All I have the above machine and every day on start up i get the failed to initiate hardware message.I have been getting around this by re initiating the motor controllers and it is good to go after this.Does anyone know the causes of the initiat
Electronics Forum | Wed Oct 23 10:22:55 EDT 2019 | maxwilko
Hey Kathy, Thank you for the link for the tech support will keep that in mind for the future! After a long series of testing different solutions we found that re-sending the Gerber data over to the 'My500' seems to have resolved the issue, we are n
Electronics Forum | Thu Oct 24 03:28:45 EDT 2019 | mfurlandea
Hello, i need an information about Fuji Aimex II and the problem when you have a multi offset pcb and you need to mount some offset with one program and the rest with a different program. So process dispense paste, mounting, changing program and moun
Electronics Forum | Wed Oct 30 02:12:39 EDT 2019 | jags
yes and thanks for this feedback. we clean with degreaser ( strong) and flux is rosin with 10% in the paste (koki). we clean after second reflow . the gap time from bottom to topside completion is 10 hours. cleans with this time. my even after 20 h
Electronics Forum | Thu Oct 31 11:47:00 EDT 2019 | slthomas
I've never tried OSP so can't speak to it's real world use. I only know what I've read about it (it has a shelf life and allegedly is less physically durable than ENIG) so I don't believe that it's a good fit for us. I understand that it solders
Electronics Forum | Mon Nov 04 07:31:54 EST 2019 | amitthepcbguy
As a manufacturer, I prefer plated nickel gold, electroless nickel immersion gold, immersion silver and palladium. These surface finishes are the best options to replace leaded surface finishes. These surface finishes can withstand higher temperature
