Electronics Forum | Wed Apr 07 11:21:26 EDT 2004 | stefwitt
Hi Dilbert, it is a step up transformer from 3 phase 208 to 3 phase 380. Each machine does not draw more than 3 Amps per phase. However, circuit breakers are rated at 15 Amps. The transformer has three power outlets, each one has a Perilex (European)
Electronics Forum | Fri Apr 02 02:37:43 EST 2004 | darburch
We are asking $10,500us for this machine, as for shipping I will see what I can come up with as we are in Canada. This is a dual wave machine with foam fluxer. It has not run in 3 years but when we had it in production results were favorable and cons
Electronics Forum | Fri Apr 02 09:01:38 EST 2004 | azdback
One thing that it doesn't make sense, I have never seen the GSM picking up one component leads down, present it to the camera leads down and reject it. Just so it can pick two more components from the same reel and present it leads up and accept it.
Electronics Forum | Fri Apr 02 15:41:38 EST 2004 | azdback
You may also want to start on the component library. Hypotetically speaking, the GSM shows the component as follows in the component library: One lead to the right, 3 leads to the left. This is the feeder default orientaion and it will be 0 degrees.
Electronics Forum | Wed Apr 07 18:47:23 EDT 2004 | pdeuel
Thanks to all of you. As it turns out,(pun), the problem was with optimization. The SOT-63 Was being picked with other parts also set to pre orent when orignally this part was not. The program was then optimized. The other parts on the other heads ca
Electronics Forum | Thu Apr 01 12:31:39 EST 2004 | russ
one more thought on this, When these boards are built new do we not have solder paste on the ground pad and then reflow? Has this caused any misregistration for you? I am assuming that you are not pasting the leads with the ground pad correct? I
Electronics Forum | Sat Apr 03 19:58:53 EST 2004 | Ken
I have used tooling holes and fiucial registration since the late '80's. In fact if your maximum "vision" tolerance is +/- 0.05mm, your in the same ball-park as locating pins. It is true that fiducial registration is more accurate. However, I woul
Electronics Forum | Fri Apr 02 09:41:45 EST 2004 | mattkehoe
We are in the process of purchasing a mole for our reflow oven. We've only looked at one model and it works well however, my accountablilty partners desire that we look at other options before we make the decision. Looking at about 3k. Opinions from
Electronics Forum | Fri Apr 02 11:23:44 EST 2004 | pjc
ECD has some advantages in terms of upgrade path. Once you buy the ECD SuperM.O.L.E., you can use it in a OvenRIDER, WaveRIDER and ReworkRIDER products. The OR, WR and RR are solder machine management devices for solder process control. Where profile
Electronics Forum | Fri Apr 02 15:59:04 EST 2004 | russ
Matt, are you still just doing SIPAD? If so, Manncorp has a profiler for about $1k It requires a p.c. to be hooked up while profiling and it won't take data points any faster than 1 point every 2 seconds. but could be adequate for your needs. (www.
