Electronics Forum | Wed Oct 12 08:34:48 EDT 2016 | assuredtech
Speaking from experience, the solder pot surface has become "wetted" so to speak, so solder will naturally wick and seek. Allow the level to go low (perhaps 1 inch plus), clean the top surface area of the solder pot as best as you can - try to remove
Electronics Forum | Mon Jun 12 07:52:21 EDT 2017 | tch
We have had this issue on our Delta 3 waves and determined that there are small pin holes in the solder pot. We had plates welded to the outside of our solder pot on the lead free wave and this bought us enough time until we could replace the wave, a
Electronics Forum | Sun Oct 09 22:07:51 EDT 2016 | geniepro
I would like to ask after glue bonding is abalibity drop. I test by force equipment that it is very difficult to drop after reflow 2. Very due by DIP machine. I check after Dip many chip drop. I wonder the glue not qualify I am using IR 130. Could yo
Electronics Forum | Wed Oct 12 02:44:38 EDT 2016 | bukas
hello, I have a problem with CP45FV Neo swing mirror. The mirror it self works fine, manually controlled it moves to correct position and back. While working it also moves properly but when machine is about to check for nozzle existence at the end of
Electronics Forum | Tue Mar 07 09:35:55 EST 2017 | buckcho
hello, I have a problem with CP45FV Neo swing > mirror. The mirror it self works fine, manually > controlled it moves to correct position and back. > While working it also moves properly but when > machine is about to check for nozzle existence a
Electronics Forum | Sun Oct 16 22:53:08 EDT 2016 | a1
Hi, I have a FUJI CP4-3 machine that is experiencing issues with missing components. The machine keeps on running even after many parts are missing and it releases the board thinking it's complete. For an example, say there is 200 components to pla
Electronics Forum | Fri Nov 04 15:16:09 EDT 2016 | mmjm_1099
Couple things here that could be the caused. Option 1: Error pass, Option 2: Vacuum release issues, Option 3: Magnetized nozzles (I have seen this occur by purchasing cheap nozzles), Option 4: Dirty Nozzles. Currently have two CP43 and one CP42 that
Electronics Forum | Mon Oct 17 13:02:28 EDT 2016 | tdemon69
i have a MPM2000 now giving me 0 - hardware limit warnings..let me start off by saying that is was giving me x axis limit problems, so i replaced the x card with diff card. set all the switch and jumpers to x card , then i got 0- hardware . so then
Electronics Forum | Thu Nov 10 11:48:03 EST 2016 | awhite
I recently had a similar problem on our 2000Hie, although ours was a 7-Hardware, Vision X. Turns out there was a short/break in the 3-wire harness that controls the Vision X Stepper. The difficulty came from the fact that this particular harness is
Electronics Forum | Thu Oct 27 14:56:29 EDT 2016 | zippi
Communication parameters is correctly. DB25(Male) > to DB9(Female) wiring as is manual, lenght 1m, > shielded. When i try read mcf CSMUTB program > stoped with error "CSM not respond" or "Cant > established communication", CSM84 display 125 > Co